ChefMaster HEA791 Instruction Manual

CHEFMASTER Water Boiler HEA791 - 10 ltr / HEA792 20 ltr CAUTION: READ INSTRUCTIONS BEFORE USING THE MACHINE ...

My Product (please complete this section) page 3 Introduction page 4 Important Information page 4 Installation page 5 Before Connection to the Power Supply page 6 Water Connection page 7 Electrical Connection page 7 Overflow & Drainage page 8 Other Safety Considerations page 8 Product Specification page 9 Parts Diagram page 10 2.0 User Guide Controls page 11 Before Using Appliance page 11 After Use page 13 3.0 Maintenance & Spare Parts Cleaning Instructions page 14 De-scaling page 15 Disposal page 16 Replacements Parts page 16 4.0 Troubleshooting & FAQ’s Fault Codes page 17 FAQ’s page 18 ...

My Product Please complete the form below: We strongly recommend that you spend some time to fill in the information below and keep it in a safe place. This will save you time if you need to contact our After Sales team. Important: The serial number can be found on the back of your appliance. Model Number: Product Code: Serial Number: Date of Purchase: / / Purchased from: .................................................................................................. Please take some time to fill in the information above and keep it in a safe place. This will save you time if y ...

To ensure you obtain full benefits from your new appliance: • Please read this instruction booklet carefully, and follow all instructions. • If you are unsure of any aspect of the installation, use or performance of your appliance, please contact our After Sales team on 03701 647 647 Important Information The use of an electrical appliance requires the following common sense safety rules. Primarily there is a danger of personal injury and secondly damage to the appliance and property. These are indicated in the instructions by the following two conventions: WARNING: Danger of perso ...

materials or faulty workmanship. This guarantee is given subject to the water boiler being used in ac- cordance with the instructions on the voltage marked on it and to the usual wear and tear standards. The guarantee does not cover consequential damage arising out of any failure acceptable under the guarantee, nor does it cover damage resulting from misuse, accident or unauthorised alterations to the water boiler. WARNING: FAILURE TO CLEAN & DE-SCALE YOUR WATER BOILER ON A REGULAR BASIS WILL INVALIDATE YOUR WARRANTY. WE RECOM- MEND THE BOILE ...

hot surfaces. • Do not let the lead run across an open space e.g. between a low socket and table. • Do not place the water boiler where the mains lead could fall into a sink. • Do not continue to use the water boiler if a fault is indicated instead. Refer to Fault codes sec- tion of the handbook. • Do not use boiler if it has been damaged in any way. • Do not use accessories or attachments which have not been recommended as they can cause hazards. • Always switch off, empty and disconnect the water boiler before moving the unit. WARNING: To avoi ...

• In hard water areas, it is advisable to fit a filtration unit to limit scale deposits. Electrical Connection • All electrical work must comply with all relevant wiring regulations and carried out by a quali- fied electrician. • Isolation switches for the appliance must not be obstructed and be within easy reaching. • To protect against fire, electric shock and personal injury, do not immerse cord, plug or water boiler in water or any other liquid. • If the mains lead is damaged, it should be discarded and replaced. WARNING: THIS APPLIAN ...

• Due to the electronic function of the water boiler, it is highly unlikely than an overflow would occur. The boiler is primarily designed so that any overflow occurrence and condensation is directly vented to the spillage tray. • As an option the boiler overflow outlet may be connected to a drainage system. Note: There may be some steam emissions from the vent at the base of the appliance during the initial fill stages but the steam emissions will lessen as the volume of water increases in the tank. WARNING: The flexible hose connected from the over flow also acts as a vent for the appliance. Under no circumstances should this ...

1. Remove yellow steam cap from steam pipe (see steam label on front of product) FAILURE TO DO SO WILL CAUSE THE PRODUCT TO STOP OPERATING WARNING: This appliance is not intended for use of persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the application by a person responsible for their safe WARNING: Turn off the power supply and remove the plug before cleaning or before replacing any parts. Product Specification Model HEA791 - 10L HEA79 ...

purpose of maintenance or emergency. The 3kW model is supplied with a 3 pin plug and lead fitted with a 13Amp fuse as standard. Important: Genuine replacement CHEFMASTER parts must be fitted by a qualified service engineer. If generic non CHEFMASTER parts are fitted, you may stop your appliance from operating safely and invalidate the warranty. On/Off switch Screen controller Hose for connection to drinking water Drip tray Removeable lid for de-scaling 10 Tap with safety lock (handle can be twisted 180o continuous flow) ...

Screen Control Before Using the Appliance WARNING: Turn off the power supply and remove the plug before cleaning or before replacing any parts. Green – Appliance is on Red – Descale or requires maintenance Power button – Turn appliance on/off 11 ...

Connection to a water supply: The blue pipe connects to the grey fitting which can be found underneath the appliance. The grey fit- ting can be unscrewed, and the blue pipe slots into it. Then screws back onto the appliance. Connection to mains water supply: The other end of the blue pipe can be fitted with the same type of grey fitting, which is connected to your main water supply. Overflow: If the appliance has an overflow, the water will be placed into the drip tray. The water in the drip tray can then be emptied out into a drain. Check and empty the drip tray on a regular basis. To start the boiler, plug it in and turn on th ...

(a) User operated flow (b) Constant flow This can be achieved by twisting the tap handle through 180o. In addition, the safety lock can be activated on the tap by twisting it through 90o.. When in this position, the tap cannot be operated accidentally. After Use Important: Once you have finished using your appliance, please ensure that the power is switched off. This helps to minimize energy consumption, ensuring greater energy efficiency and preventing non-users from burning themselves if they touch the unit. 13 Can be changed to continuous ϐlow Hold to receive hot water ...

WARNING: Turn off the power supply and remove the plug before cleaning, de-scaling or before replacing any parts. • This appliance shall be operated in ambient temperature between 5 - 30°C. • Do not allow your appliance to freeze. If this happens, do not operate the appliance and contact manufacturer. Cleaning Instructions We recommend cleaning your water boiler on a regular basis. Failure to do this may result in the appli- ance not operating to its full potential and could invalidate your warranty. CLEANING WARNING: Disconnect from the electrical supply before cleaning and allow water boiler to cool. Important: Do ...

from the boiler and access to live electrical components. Always use a de-scaling agent suitable for stainless steel. Please note any relevant Personal Protective Equipment must be worn when undertak- ing any de-scaling. 1. Isolate the boiler from electrical supply. 2. Allow the water to cool approximately 60oC 3. Remove the screw on the back of the boiler and remove the top cover. (PICTURE 1 & 2) 4. Remove the insulation on top of the tank, unscrew and remove the tank lid. (PICTURE 3,4 & 5 5. Add de-scaling agent in accordance with manu ...

Please recycle where facilities exist. Check with your local authority for recycling advice in your coun- try. Please dispose of this appliance in the accordance with the WEEE Directive. Replacement Parts For further information or to purchase any spare parts, please do not hesitate to contact the CHEF- MASTER service line on 03701 647 647. Please ensure that you have your model number, product code and the serial number of your product. The serial number can be found at the rear of the appli- ance. 16 ...

to flash afer descaling the appliance, please contact your CHEFMASTER distributor. 4.0 – Troubleshooting Fault Codes Your boiler is fitted with a fault system that is able to detect fault conditions. Some of the conditions are less serious and the boiler will continue to operate normally, while other faults are more serious and will disable the appliance. Before calling the service line, make sure that the appliance is switched off at the main supply. Draw off a small amount of water after and then switch back on after 10 min- utes. If the fault continues, please call the service l ...

Yes, your appliance should be positioned on a flat, level surface that is capable of taking the weight of the appliance when full of water. Consideration must also be given to serving require- ments and safe operational access to the appliance must also be ensured. For a detailed over- view of installation requirement, please refer to pages 4, 5 and 6 of this instruction book. 2. There is no water coming from the tap? Check appliance is connected to the mains water/power supply and there is no blockage/kink in the supply hose. 3. Why is the mains neon not illuminating ...