Falltech 6015 Instructions Manual

Text of the manual

Instructions for Full Body Harnesses (FBH’s)

Warning! THE USER OF THIS EQUIPMENT, AND THE USER’S EMPLOYER MUST READ AND COMPLY WITH THESE INSTRUCTIONS. FURTHERMORE, THE USER AND THE USER’S EMPOLYER MUST READ AND COMPLY WITH ALL INSTRUCTIONS, LABELS WARNINGS AND MARKINGS INCLUDED WITH EACH COMPONENT OF THE FALL ARREST SYSTEM OF WHICH THIS PRODUCT IS

Section 1: Warnings and Advisories

This product is to be used as a part of a personal fall arrest system, and should be used only with compatible components. Please see Advisory #3 in this section for further details. Failure to use compatible components can result in a failure of the system to perform as intended, which may result in serious injury or

Don’t use this component near moving machinery which may

entangle any part of your PFAS.  Don’t use this FBH if there are any signs of excessive wear, soil or surface contamination such as paint, oil, grease, dirt or any other substance which may inhibit adjustability or may change the characteristics of the harness in any way.  Don’t use t

platforms and capable of supporting at least 5,000 pounds (22.2 kN) per

employee attached, or shall be designed, installed, and used as follows: as part of a complete personal fall arrest system which maintains a safety factor of at least two; and under the supervision of a qualified person.” Ensure that the structure to which you are attaching your

back d-ring of their full body harness and tied-off to the structure

on which they are positioning as a back up device. 2.8: Free-Fall Free-Fall is the distance that a worker will fall before the connecting device or deceleration device elements of the PFAS will begin to engage during a fall event. OSHA allows a maximum Free-Fall Distance of 6’ (6

Swing-Fall is the phenomenon that occurs when the user falls from a

location that is not directly adjacent to, or directly below the anchorage connector. This is also referred to as the “pendulum effect”, and can result in a situation where the user is not only falling vertically, but is also swinging on the horizontal as well. This can bring ad

these requirements, please go to www.osha.gov to review the OSHA

requirements. Copies of the ANSI standards are available at www.asse.org in the e-standards store. 3.2: Approved Applications FallTech Full Body Harnesses (FBH’s) are available in a wide variety of different configurations to address the specific needs in nearly every workplace. Th

Ironman or Ironman+ shock absorbing lanyard is used. Some FallTech

self-retracting lifelines may also be used to rig your PFAS for up to 12 feet of free fall. Please contact FallTech for additional details. 3.4: Specialty Applications Where fall arrest is concerned, there are many applications that are highly specialized which require Full Body Ha

3.6: Instructions for Use by Application

Many FallTech Full Body Harnesses can be used for more than one application under a variety of conditions. Care has been taken to address the most common applications and uses in the instructions below. If you are unsure about whether your FBH is suitable for your application, or if you are unsure about how

Work Positioning/ Tower Work:

FallTech Full Body Harnesses which are equipped with side or hip D- rings may be used for work positioning when used with one of the connecting devices shown in Table 3.1. 1. Select the appropriate FallTech FBH based on the work conditions, specific hazards and the weight of the user. 2. Read, understand and comply with

More Falltech Security Sensors Owners Instructions: