EMC VNX Series Replacing Manual

EMC CONFIDENTIAL version: 4.5 1 of 51 Replacing the Data Mover Enclosure (DME) T o p i c VNX5300 Procedures S e l e c t i o n s VNX5300 Activity Type: Hardware Replacements VNX5300 File/Unified HW Replacements: Data Mover Enclosure (DME) Generated: 2013/7/24 11:21:15 SolVe Generator Updated: 五月 30, 2013 IMPORTANT: To be s ...

EMC CONFIDENTIAL version: 4.5 2 of 51 Contents Handling Field Replaceable Units (FRUs)......................................................................... 4 FRUs and Power Issues ..........................................................................................................................4 Avoiding Electrosta ...

EMC CONFIDENTIAL version: 4.5 3 of 51 Reconnect Blade Enclosure Cables ..........................................................................................27 Task 8: Configure the replacement BE Resume PROM...................................................................27 Set up the Work Environment on the Blade .... ...

EMC CONFIDENTIAL version: 4.5 4 of 51 Handling Field Replaceable Units (FRUs) This section describes precautions you must take and general procedures you must follow when removing, installing, or storing field-replaceable units (FRUs). The procedures in this section apply to FRU handling during hardware upgrades as well as du ...

EMC CONFIDENTIAL version: 4.5 5 of 51 To use it, attach the clip of the ESD wristband (strap) to any bare (unpainted) metal on the cabinet enclosure; then secure the wristband around your wrist with the metal button against your skin. Emergency procedures (without an ESD kit) In an emergency, when an ESD kit is not available, ...

EMC CONFIDENTIAL version: 4.5 6 of 51  When installing multiple disks in a powered-up system, wait at least 6 seconds before sliding the second and each subsequent disk into the system.  Place a disk module on a soft, antistatic surface, such as an industry-standard antistatic foam pad or the container used to ship the ...

EMC CONFIDENTIAL version: 4.5 7 of 51 Receive an email notification If the system detects a problem with an internal component, the system may send an email notification outlining the problem detected and recommending steps to correct the problem. If you receive an email notification, follow the recommended steps described in ...

EMC CONFIDENTIAL version: 4.5 8 of 51 Figure 1 Unlocking and removing the Blade enclosure (front bezel) Check the Blade enclosure fault LEDs If you are near the front of the system, you can easily check the Blade enclosure fault LED. 8. [ ] Locate the Blade enclosure. For a multi-Blade enclosure system, if you recorded the in ...

EMC CONFIDENTIAL version: 4.5 9 of 51 Recheck the Unisphere to see if another component has faulted. If the Unisphere shows another component has faulted, it might need to be replaced instead of a Blade enclosure. Task 2: Disabling ConnectHome and Email Notifications For VNX OE for File 7.0 or later, use a HyperTerminal or Pu ...

EMC CONFIDENTIAL version: 4.5 10 of 51 EMC_PRODUCT_SERIAL_NUMBER="FCNCH095103338 " VENDOR_NAME="Blank " LOCATION_OF_MANUFACTURE="Blank " YEAR_OF_MANUFACTURE=" " MONTH_OF_MANUFACTURE=" " DAY_OF_MONTH_OF_MANUFACTURE=" " ASSEMBLY_NAME=" " /> Table 2 ...