National Instruments C Series Getting Started Manual

Note Before you begin, complete the software and hardware installation procedures in your chassis documentation. Note The guidelines in this document are specific to the NI 9467. The other components in the system might not meet the same safety ratings. Refer to the documentation for each component in t ...

The NI 9467 is suitable for use in Class I, Division 2, Groups A, B, C, D, T4 hazardous locations; Class I, Zone 2, AEx nA IIC T4 and Ex nA IIC T4 hazardous locations; and nonhazardous locations only. Follow these guidelines if you are installing the NI 9467 in a potentially explosive environment. Not following these ...

install a protection device between the external power supply and the Vsup pin. The device must prevent the Vsup-to-COM voltage from exceeding 50 V if there is a transient overvoltage condition. Special Conditions for Hazardous Locations Use in Europe and Internationally The NI 9467 has been evaluated as Ex nA ...

ATEX/IECEx-certified enclosure with a minimum ingress protection rating of at least IP54 as defined in IEC/EN 60079-15. Caution The enclosure must have a door or cover accessible only by the use of a tool. Electromagnetic Compatibility Guidelines This product was tested and complies with the regulatory requirements ...

expressly approved by National Instruments could void your authority to operate it under your local regulatory rules. Caution To ensure the specified EMC performance, operate this product only with shielded cables and accessories. Special Conditions for Marine Applications Some products are Lloyd� ...

The NI 9467 is a stationary GPS timing module for C Series platforms. It provides accurate timing and geographic location information to the C Series host, which enables synchronization of C Series systems. Start-Up Behavior At start-up, the NI 9467 automatically begins determining its location through a process known as self-survey. During ...

marked as unhealthy) and contains coarse orbit information. The GPS satellites broadcast the ephemeris and almanac data every 30 seconds. Therefore, it usually takes approximately 30 seconds for it to receive the ephemeris and almanac data and start computing location and timing fixes. Status LE ...