FIC VT-501 Installation Procedures Manual

configure your system to suit your requirements. This chapter contains information on the various jumper settings on your mainboard. To set up your computer, you should follow these installation steps: I Step 1 - Set system jumpers I Step 2 - Insta ...

Jumpers Jumpers are used to select the operation modes for your system. Some jumpers on the board have three metal pins with each pin representing a different function. To “ set” a jumper, a black cap containing metal contacts is placed over the jumper pin/s according to the required configuration. A jum ...

14 Clear Password: CPW This jumper allows you to set the password configuration to “ Enabled” or “ Disabled” . You may need to enable this jumper if you forget your password. Flash EPROM Type: EP1, EP2 and EP3 These three jumpers allows you to configure the mainboard when using the MXIC 28F1000, Intel 28F001, SST 29EE010 (def ...

DRAM and SDRAM The working space of the computer is the Random Access Memory (RAM). The system cannot act upon data unless it is loaded into RAM. When more memory is added, the working memory of the computer is larger, thereby increasing total performance. The VT-501’s RAM is comprised of two industry st ...

16 DRAM and SDRAM Configuration TOTAL MEMORY SIMM BANK0 (72-PIN X 2) DIMM BANK1 (168-PIN X 1) 8MB 4MB & 4MB 8MB 16MB 8MB & 8MB 4MB & 4MB 8MB 24 MB 8MB & 8MB 8MB 32 MB 8MB & 8MB 16MB 16MB & 16MB 40MB 16MB & 16MB 8MB 48MB 16MB & 16MB 16MB 64MB 16MB & 16MB 32MB* 32MB & 32MB 72MB 32MB & 32MB 8MB 80MB 32MB & 32MB 16MB 96MB 32MB & 32MB 32MB ...

CAUTION : Always turn the system power off before installing or removing any device; and see “Handling Precautions” at the start of this manual. 1. Locate the SIMM slots on the mainboard. (See figure below.) NOTE : BANK 0 and BANK 1 can use different type SIMM ...

18 Install DIMM Complete the following procedures to install DIMMs: 1. Locate the DIMM slot on the mainboard. (See figure below.) 2. Insert the DIMM straight down onto the DIMM slot with both hands carefully until the clips on the ends of the slot close up to hold the DIMM firmly. Remove DIMM Press the clips on the ends of the slo ...

Burst SRAM. Please note that for 256KB secondary cache, M2 and M3 should be mounted with 32Kx32 Pipeline Burst SRAM. (Please refer to your dealer for the 512KB cache upgrade and the appropriate SRAM type.) ...

20 256/512KB Cache SRAM NOTE : Use the correct chips for the amount of cache memory you want to add. Install both the correct Cache and Tag SRAM. ...