EMC DATA DOMAIN DD880g Installation And Setup Manual

1. Install Hardware 2. Define the Data Domain system information for your site 4. Perform initial system configuration 5. Configure the system for data access 6. Configure optional software 7. Perform optional additional system configuration Installation and Setup Steps 1 5 4 3 2 6 All plug-in modules and blank plates are part of the fire enclosure and must be removed only when a replacemen ...

FIGURE 1: REAR PANEL AND INPUT/OUTPUT CONNECTIVITY Slot 7 PCI-e (x8) Slot 6 PCI-e (x8) Slot 5 PCI-e (x8) Slot 4 PCI-e (x8) Slot 3 PCI-e (x4) Slot 2 PCI-e (x4) Slot 1 PCI-e (x4) NVRAM 2 NVRAM 1 Ethernet 1 or VTL 2 or empty VTL 1 or Ethernet 2 or empty Empty Gateway FC HBA 1 Gateway FC HBA 2 FIGURE 2: FRONT PANEL AND DISK LOCATIONS Blue circles illustrate the locations of the four hot-swap disks. All the other disk s ...

4 The storage array can have single or multiple controllers. Each controller can have multiple ports. 4 One storage controller port is required for each connection to the gateway system. 4 A SAN-attached storage controller port used for gateway connectivity cannot be shared by other SAN-attached hosts that access the storage array. 4 Optional redundant connectivity is supported. If you do not use redundant conne ...

are discharged. Refer to the NVRAM Battery Charging Instructions for more information. Log into the system with the user name of sysadmin. The password is the system’s serial number. A Configuration Wizard is provided. There are six sections to the configuration: Licenses, Network, File System, System, CIFS, and NFS. Complete each of the six sections. USING THE CLI CONFIGUR ...

Troubleshooting Tips If you purchased optional software for the Data Domain system such as Replicator or Retention Lock, the licenses are enabled on your Data Domain system prior to shipment. You need to configure them for use. Details configuring the optional software can be found in the DD OS Administration Guide. Access the latest documents at https://my.data ...

EMC believes the information in this publication is accurate as of its publication date. The information is subject to change without notice. THE INFORMATION IN THIS PUBLICATION IS PROVIDED “AS IS.” EMC CORPORATION MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WITH RESPECT TO THE INFORMATION IN THIS PUBLICATION, AND SPECIFICALLY DISCLAIMS IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A ...