Mircom QDV-1000 Manual
Text of Mircom QDV-1000 Manual
QDV-1000 Digitized Voice Module and
QDVP-100 Configurator for Digitized Voice
The QDV-1000 Digitized Voice Module provides digitized voice messaging for the QX-5000 Emergency Zone Audio &
Firefighters’ Telephone System. The QDVP -100 Configurator provides a means of programming voice messages for
the QDV-1000 Digitized Voice Module.
The procedure for digi
1. Verify that jumpers JP1 and JP2 on the QDV-1000 are over pins 2 and 3 for both, that is the jumpers are in
the left-most positions for both. In case that the ‘Manual Message’ option is used, move JP2 over to pins 1
and 2, which is the right-most position instead.
2. Locate the J8 header on the QIF-5000B module; remove al
QDV-1000 Voice Message Recording Procedure
Equipment Required:
1. Personal Computer with sound card.
2. Audio cable with mini stereo plug at both ends (to plug into the computer and the stereo jack of the QDVP-
100.
3. Wire to 24V D.C. power supply such as Filtered smoke detector supply voltage at the Fire Alarm Panel or
24V DC transformer with power cord wi
LT-901 Rev.4 Aug 2006
Page 4 of 10
Setting up the computer for recording:
On the computer, launch one of the wave player software programs and load the message file to be recorded. Play
the message and listen to the play back through the speaker. Adjust the volume level if required. The first message to
be recorded on any QDV-0001 chip must be SO-
LT-901 Rev.4 Aug 2006
Page 5 of 10
IMPORTANT: Reserved message locations:
Some message locations on QDV-1000 are reserved for special features:
1. Message position 1 of each chip is reserved for supervision purposes and should not be used for alarm
messages. Special tone file SO-195.wav must be used.
2. If Massachusetts (Boston) code signaling is