Dell K804N Getting Started With Your System

External Battery Module for use with 3750W and 4200W UPS models Getting Started With Your System Démarrer avec Votre Système Erste Schritte mit Ihrem System Начало работы с системой Introducción de su Sistema 系统使用入门指南 系統使用入門指南 사용자시스템시작하기 はじめにシステムに� ...

External Battery Module for use with 3750W and 4200W UPS models Getting Started With Your System K804N, H952N, J730N, K805N J739N w w w . d e l l . c o m | s u p p o r t . d e l l . c o m ...

NOTE: A NOTE indicates important information that helps you make better use of your software. DANGER: A DANGER indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. WARNING: A WARNING indicates a potentially hazardous situation which, if not avoided, could result in death or injury. CAUT ...

regulatory information. What are You Looking For? Find It Here S The user's guide for my UPS S The user's guide for the Dell Network Management Card S Dell UPS Management Software NOTE: Documentation and software u ...

Installation and Startup CAUTION: Before performing the procedures in this document, read and follow the safety instructions and important regulatory information in your Safety, Environmental, and Regulatory Information document. Unpacking the External Battery Module 1 Open the outer carton and remove the accessories packaged wit ...

| Lifting the Cabinet CAUTION: The cabinet is heavy (53 kg/116.8 lb). Lifting the cabinets into the rack requires a minimum of two people. 1 With one person on each side, carefully lift the cabinet out of the outer carton using the handles on the cardboard and set it on a flat, stable surface. 2 Discard or recycle the packaging in ...

Rackmount Setup CAUTION: The cabinet is heavy (53 kg/116.8 lb). Lifting the cabinets into the rack requires a minimum of two people. Installing the Rails NOTE: The instructions are the same for square-hole racks and unthreaded, round-hole racks. The rails fit both rack styles. The round-hole rack is shown in the illustrations. 1 ...

| 3 Attach the rails to the rack: Engage the back end of the rail until it fully seats on the vertical rack flange and the hook latch locks in place. Pull the rail toward the front. Push the front end of the rail until it fully seats on the vertical rack flange and the hook latch locks in place. Installing the Cabinet NOTE: Install ...

Securing the Cabinet 5 Secure the front of the cabinet to the rack using the thumbscrews on the mounting brackets. Tighten by hand; do not use power tools. Installing the EBM Front Cover 6 Install the EBM front cover. ...