V2 ALFARISS Manual
Text of the manual
ATTUATORE ELETTROMECCANICO 24V IRREVERSIBILE A
CREMAGLIERA PER CANCELLI SCORREVOLI FINO A 300 KG
DI PESO
24V ELECTRO-MECHANICAL IRREVERSIBLE RACK ACTUATOR
FOR SLIDING GATES UP TO 300 KG
OPERATEUR ELECTROMECANIQUE 24V IRREVERSIBLE A
CREMAILLERE POUR PORTAILS COULISSANTS JUSQU'A
300 KG DE POIDS
MOTOR ELECTROMECANICO 24V IRREVERSIBLES A
CREMALLERA PARA PUERTAS
1 - GENERAL SAFETY INFORMATION....................................................................................................................................28
1.1 - PRELIMINARY CHECKS and IDENTIFICATION OF THE TYPE TO BE USED ..................................................................28
1.2 - TECHNICAL ASSISTANCE SERVICE .......
AUTOMATION DEVICE INSTALLERS MANUAL
1 - GENERAL SAFETY INFORMATION
Prior to proceeding with installation, it is essential the instructions be read in full, since they contain important information
regarding safety, installation, use and maintenance.
• Anything not expressly described in these instructions is prohibited; unforeseen uses may be a
Group 1 - Only a limited number of people are authorised for use, and closure is not in a public area. Examples of this type are gates inside
business premises, where the sole users are employees, or a part of them who have been suitably informed.
Group 2 - Only a limited number of people are authorised for use, but in this case, closure is in a p
Gate maximum weight
Kg
300
Power supply
V / Hz
230 / 50
Maximum power
W
150
Idling current
A
0,9
Full load current
A
3
Gate maximum speed
m/s
0,18
Maximum thrust
N
330
Duty cycle
%
50
Pinion
-
M4-Z16
Working temperature
°C
-20 ÷ +55
Motor weight
Kg
7,5
Protection degree
IP
44
Maximum load on 24 Vac accessories
mA
500
Protection fuses
-
F1 = T1,6
3 - INSTALLATION OF THE MOTOR
3.1 - POSITIONING OF THE MOTOR
To fix ALFARISS, follow the instructions below:
1. use the measurements indicated in the drawing for the
foundations
2. Arrange for one or two pipes for the passage of electric
cables
3. Assemble the 2 clamps on the anchoring plate and fix them
with the 4 bolts issued with the motor
4. Pour
3.3 - FIXING OF THE MOTOR
Check the following points:
1. the motor must be on a levelled surface and perfectly parallel
to the gate
2. the distance between pinion and rack must be 1 or 2 mm.
If needed, adjust the 4 grains
3. the rack must be trued up with the pinion of the motor
4. the minimum distance between the maximum overall of the
gate and the