Toro Dingo 320-D Operator's Manual

Text of the manual

Form No. 3402-775 Rev C

320-D Tool Carrier Model No. 22337CP—Serial No. 315000001 and Up Register at www.Toro.com. Original Instructions (EN) *3402-775* C

This product complies with all relevant European

directives. For details, please see the separate product specific Declaration of Conformity (DOC) sheet. DANGER There may be buried utility lines in the work area. Digging into them may cause a shock or an explosion. Have the property or work area marked for buried lines and do not dig in marked areas. Contact

Think Safety First.............................................. 19

Adding Fuel ...................................................... 19 Performing Daily Maintenance.......................... 21 Starting the Engine ........................................... 21 Driving the Machine.......................................... 22 Shutting Off the Engine.........

Evaluate the terrain to determine what accessories

and attachments you need to properly and safely perform the job. Use only the accessories and attachments that are approved by the manufacturer. • Wear appropriate clothing including gloves, eye protection, long pants, substantial slip-resistant footwear, and hearing protection. Tie back long hair and

Do not place your feet under the platform, if

equipped on your machine. • Lightning can cause severe injury or death. If lightning is seen or thunder is heard in the area, do not operate the machine; seek shelter. Slope Operation Slopes are a major factor related to loss-of-control and tip-over accidents, which can result in severe injury or death. All

Never tamper with the safety devices.

• Keep the machine free of grass, leaves, or other debris buildup. Wipe up any spilled oil or fuel. Allow the machine to cool before storing. • Use extra care when handling fuel; it is flammable and its vapors are explosive. – Use only an approved container. – Never remove the fuel cap(s) or add fuel when the

Safety and Instructional Decals

Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost. decal136-5785 136-5785 decal120-0627 120-0627 1. Cutting/dismemberment hazard, fan—stay away from moving parts; keep all guards and shields in place. decal100-1701 10

Bucket tilt— down

10. Engine—run 2. Tipping hazard—do not step off operator platform with load raised; always operate with the heavy end of the machine pointed uphill; carry loads low; never jerk the controls; use a steady, even motion; maximum load is 234 kg (515 lb).

Other Utility Vehicle Manuals