Overland Storage REO 4600 Installing Or Replacing

Page 1 of 5 SnapServer® 2000 Series/REO® 4600 Installing or Replacing a PCIe Card This document describes how to install a new PCIe card or remove and replace an existing PCIe card or riser in a SnapServer 2000 Series server or REO 4600 appliance. Follow this procedure carefully. Improper installation may ...

Page 2 of 5 b. Press the bezel latch and pull that latch side forward a few inches. c. To release the tabs on the opposite side, pull the bezel away from that flange. Set the bezel aside. 2. On the drive carrier, press the button to release the assembly handle. 3. Use the handle to pull the assembly out. NOT ...

Page 3 of 5 • On a REO 4600, the Hardware Compression card (if installed) is always in the top slot. • All other cards can be installed in any available slot. Replace a RAID Controller, SAS UIO Module, Fibre Channel, Parallel SCSI, Ethernet, or Hardware Compression Card 1. Remove any cards above the card ...

Page 4 of 5 Install a New Card Depending on the your server model, you can upgrade any SnapServer 2000 Series or REO 4600 to include the following: • Ethernet card • Parallel SCSI card (SnapServer NAS N2000 only) • Hardware Compression card (REO 4600 only) • Fibre Channel card (REO 4600 only) IMPORTA ...

Page 5 of 5 Verify the Update Power ON the Server IMPORTANT: Always turn ON any Expansion E2000 arrays before powering up your server. This enables the server to discover the arrays. 1. Turn on all expansion arrays by pressing their Power buttons for no more than one (1) second. 2. Wait until all the expans ...