Overland Storage NEO 8000E Remove & Replace Instructions

Belt Drive Assembly Remove & Replace Instructions NEO-8131 May 2014 10400594-001 ...

9112 Spectrum Center Blvd. San Diego, CA 92123 U.S.A. Tel: 1.877.654.3429 (toll-free U.S.) Tel: +1.858.571.5555, Option 5 (International) Fax: +1.858.571.0982 (general) Fax: +1.858.571.3664 (sales) www.overlandstorage.com NEO 8000e Z-axis BDA R&R Instructions 10400594-001 ©2014 Overland Storage, Inc.  2 ©2014 Overland Storage, In ...

 3 Preface This document guides you through the process of removing and replacing either a front or rear Belt Drive Assembly (BDA): 1. Chapter 1 describes preparing the library for a BDA removal. 2. Select the appropriate chapter for removing, and replacing the appropriate BDA: • Chapter 2 covers the removal a ...

 4 NEO 8000e Z-axis BDA R&R Instructions Preface Conventions This document exercises several alerts and typographical conventions. Alerts Typographical Conventions Information contained in this guide has been reviewed for accuracy, but not for product warranty because of the various environments, operating syste ...

 5 Chapter 1 Library Preparation Overview A Z-Axis Belt Drive Assembly (BDA) consists of a pole with belts and pulleys that move one end of the Shuttle Track Assembly vertically inside the library. There are two BDAs in every library (front and rear), each with slightly different overall assemblies. Each BDA has ...

 6 NEO 8000e Z-axis BDA R&R Instructions 1 - Library Preparation Unpacking the Retrofit Kit CAUTION: NEVER handle the BDA with your bare hands. Contamination from the oils on your skin can cause the BDA to stick. Always wear the provided cotton gloves. Carefully unpack the new components noting how they are pac ...

 7 NEO 8000e Z-axis BDA R&R Instructions 1 - Library Preparation Required Tools These tools are required for the proper removal and replacement of the BDAs: • #1 and #2 Phillips screwdrivers (with torque handle, if available) • #2 stubby Phillips screwdriver • 5/8-inch open-ended wrench • 1/8-inch hex ke ...

 8 NEO 8000e Z-axis BDA R&R Instructions 1 - Library Preparation Prepare Media Drawers for Removal WARNING: Exercise care when removing the media drawers from the library units. Fully-loaded drawers weigh approximately 58 pounds (26.3 kg). Also, when the drawers are removed, the inner rails extend several inche ...

 9 NEO 8000e Z-axis BDA R&R Instructions 1 - Library Preparation Power Down the Library WARNING: Working with a powered NEO 8000e library may cause physical harm and severe damage to the unit’s circuitry. Always power down a library before removing components. AVERTISSEMENT: Travailler avec un moteur NEO 800 ...

 10 NEO 8000e Z-axis BDA R&R Instructions 1 - Library Preparation Remove Media Drawers 1. Remove each media drawer: a. Pull the drawer out until it stops. IMPORTANT: If removing tapes to minimize the weight on a partitioned library, be sure to keep them together on a secure surface and labeled so they can be re ...