Oriental motor BXM230 Operating Manual

Only qualified personnel of electrical and mechanical engineering should work with the product. Use the product correctly after thoroughly reading the section "Safety precautions." In addition, be sure to observe the contents described in warning, caution, and note in this manual. The product described in this document has been designed and manufactured to be incorporated in general industrial equipment. Do not ...

This section covers restrictions and requirements the user should consider when using the product. Be sure to match the motor output power with the driver output power. Wiring z z Connecting the motor and driver To connect the motor and driver, always use the dedicated connection cable (sold separately). z z How to fix the cable Fix the cable at the positions near the connector so that no stress is applied on the connector part. A wid ...

label. Check the motor model and the gearhead model against the model name shown on their nameplates, respectively. The box () in the model name indicates the number representing the gear ratio. z z Standard type Combination type-parallel shaft gearhead Output power Model Motor model Gearhead model 30 W BXM230- BXM230-GFS GFS2G 60 W BXM460- BXM460 ...

Standard type The figure shows a motor of 200 W or 400 W. Motor Encoder Protective Earth Terminal Gearhead Hollow output shaft Mounting hole (4 locations) Key slot Motor cable Encoder cable Installation This section explains the installation method of a load in addition to the installation location and installation method of the product. „ „ Installation location Install the product in a well-ventilated l ...

When the gearhead is installed by using its front side as the mounting surface, use the boss section of the output shaft to align the center. Hexagonal socket head screw Mounting plate Plain washer Spring washer Nut z z Using the rear side as the mounting surface Hexagonal socket head screw Mounting plate Plain washer Spring washer Hexagonal nut z z Installing the safety cover After installing a load, atta ...

z z Combination type-parallel shaft gearhead, round shaft type When installing a load on the motor or gearhead, align the center of the motor output shaft (gearhead output shaft) with the center of the load shaft. Note •• When coupling the motor or the gearhead with a load, pay attention to centering, belt tension, parallelism of pulleys, etc. Also, firmly secure the tightening screws of the coupling or pulleys. •• When ins ...

10 mm (0.39 in.) 20 mm (0.79 in.) Distance from mounting surface Axial load Radial load Model Permissible radial load [N (lb.)]∗1 Distance from gearhead mounting surface Permissible axial load [N (lb.)] Gear ratio 10 mm (0.39 in.) 20 mm (0.79 in.) BXM230 5, 10 450 (101) [410 (92)] 370 (83) [330 (74)] 200 (45) 15 to 200 500 (112) [460 (103)] 400 (90) [370 (83)] BXM460 5, 10 800 (180) [730 (164)] 660 (148) ...

•• Oriental Motor shall not be liable whatsoever for any problems relating to industrial property rights arising from use of any information, circuit, equipment or device provided or referenced in this manual. •• Characteristics, specifications and dimensions are subject to change without notice. •• While we make every effort to offer accurate information ...