Mircom QIF-2011 Installation Instructions Manual

Text of Mircom QIF-2011 Installation Instructions Manual

August 2017 Page | 1

QIF-2011 Audio Signal Interface Module Installation Instructions The QIF-2011 allows external audio signals to be sent over the paging channel of the FleX-NetTM. This configuration will not interfere with the fire alarm/MNS audio system, even in the case of complete power failure of the QIF-2011. Up to four different

August 2017 Page | 2

Figure 1: QIF-2011 Interface Controls and Indicators Terminal Identification Table Terminal Function SH (beside R1) Audio signal shield connection R1 External signal #1 audio return H1 External signal #1 audio positive. Connect H1 and R1 to external signal source with highest priority. M1 External signal #1 control in

August 2017 Page | 3

R3 External signal #3 audio return H3 External signal #3 audio positive. Connect H3 and R3 to external signal source. M3 External signal #3 control input return C3 External signal #3 control input positive. M3 and C3 typically connect to normally open dry contact used to activate input 3. SH (beside R4) Audio signal s

August 2017 Page | 4

Jumper Identification Table Figure 2: X1 TO X4 Jumper Configuration (location on board shown in Figure 1) Jumper Function (when jumper is inserted) Z1 (two jumpers) Signal 1 audio line supervision enable. Both jumpers must be installed and a 3.9K end of line resistor is required. In addition, coupling capacitors may b

August 2017 Page | 5

LED and Potentiometer Identification Table Typical System Connection Requirements: Figure 3 and 4 describes a fire alarm audio system where external input 2 signal is coming from an existing emergency audio system 70V RMS or 25V RMS output and input 4 from a background music source at 0dB. Priority for paging is a Fle

August 2017 Page | 6

Wiring: The following diagrams provide wiring information for the QIF-2011 used to connect external signal sources to the ANC-5000 FleX-NetTM audio controller per this typical system example. The signal side connections must be done as per Figure 3 and the connection to the ANC-5000 as per Figure 4. Priority (A. PRIO)

Mircom Control Unit Owners Instructions: