Metra Electronics 95-9403B Installation Instructions

Text of Metra Electronics 95-9403B Installation Instructions

CAUTION! All accessories, switches, climate

controls panels, and especially air bag indicator lights must be connected before cycling the ignition. Also, do not remove the factory radio with the key in the on position, or while the vehicle is running. Metra. The World’s Best Kits.® MetraOnline.com © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 2/19/18 INST95-9403B INSTALL ATION INSTRUCTIONS 95-9403B KIT FEATURES • ISO DDIN radio provision • P

1.800.221.0932 | MetraOnline.com

2 1. Unclip and remove the “H” shaped trim around the steering column and speedometer cluster. 2. Remove (2) Torx T20 screws now exposed securing the dash panel surrounding the radio display. 3. Open the passenger door, then unclip and remove the panel on the side of the dash. Remove (2) Torx T20 screws now exposed. 4. Unclip and remove the trim panels to the left and right of the front of the center console. Remove

Metra Electronics 95-9403B REV. 2/19/2018 INST95-9403B

3 KIT ASSEMBLY KIT PREPARATION Please visit Metraonline.com for Kit Preparation illustrations. ISO DDIN radio provision 1. Attach the radio brackets to the radio using the screws supplied with the radio. (Figure A) 2. Locate the factory wiring harness and antenna connector in the dash and complete all necessary connections to the radio. Metra recommends using the proper mating adapter from Metra and/ or Axxess. Note: The factor

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow. ® Metra recommends MECP certified technicians IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH.

Metra Electronics Automobile Accessories Owners Instructions: