AUSSIE TONNEAU ATB01030 Installation Instructions Manual

Text of the manual

TONNEAU INSTALLATION INSTRUCTIONS

FORD RANGER PX SINGLE CAB WITH HEADBOARD (CHECK IMAGE) JUNE 2013 – CURRENT PART NUMBER: ATB01030 BASIC TOOLS REQUIRED - Rivet gun, Drill, 4.5mm Drill bit, Measuring tape, Silicon sealant, Anti-corrosive primer. CONTENTS 1 x Tonneau cover 3 x Aluminium rope track (476mm) 4 x Bar Brackets 2 x Tonneau supp

1. Using a 4mm drill bit, drill a hole 50 mm in from each end

and 9 mm up from the bottom of the 3 pieces of rope track as shown in Figure 1a. 2. Join the 3 pieces of rope track together using the 2 pieces of wooden dowl as shown in Figure 1b Figure 1b 3. Sit the flat side of the assembled rope track on the tailgate side of the headboard with the 'C' channel

8. Using the Bar Bracket as a guide, drill into the body. Apply rust inhibitor and rivet the front and rear

holes to complete attachment of the Bar Bracket. Repeat for the passenger side of vehicle. 9. Measure 465mm up from the bottom edge of the tail gate and 25mm, 295mm & 562mm in from the outside edge of the driver’s side of the tailgate and mark button

15. Slide the front of the tonneau cover into the rope track

as shown in Figure 9 and centre the cover. Drape the cover over the cab. 16. Install the support bar (Refer Multi Fit Support Bar Page) then drape cover over support bar and fit rear bunji's to buttons on tailgate as shown in Figure 10 17. To fit side buttons, work from the rear most bunjis toward

22. Partially peel the backing paper from the driver’s side seal.

Align the notched section and the first hole to the vehicle and apply the seal tape to cover the gap between the headboard and the cabin end of the tub. Refer figure 14 23. Remove the rest of the backing paper and finish applying the seal. 24. Repeat for Passenger side. 25. Use the remainder

3.2 FITTING MULTI-FIT SUPPORT BAR

1. Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket holders with the holes facing to the ground (so the grub screws don’t rub against the tonneau), as shown above and then with a white pencil make a mark through the small holes of the hollow bar onto the solid ends. This is

Other Automobile Accessories Manuals