CommScope FOSC-500-AA Installation Instruction

Cold applied Inline Splice Closure for small Fiber Optic Cables (maximum 48 splices) 1 Introduction 1.1 Product description 2 General 2.1 Tools 2.2 Kit contents. 3 Cable preparation 3.1 Loose tube 3.2 Central core 4 Cable installation A Loose tube B Central core 5 Fiber organisation A 24 spli ...

kit content may be different. Some of the components will be pre-assembled in the closure depending on the selection and the ordering. The minimum content will be: the joint body & cover with • Pre installed - 1 splicing tray (24/48) - 1 splicing tray cover - 2 step splice holders - ...

3.2.1 Prepare the cable according to the drawing. Strip the cable over a length of 1000 mm (40”) for the 24 splice tray, 1300 mm (50”) for the 48 splice tray and remove the central core up to 35 mm (1.5”) from the cable cut. 4 Cable installation 4.1 All the fibers should be cleaned and free from cable grease or di ...

body on the cable termination point. 4.8 Hold the cable in the correct position and secure the cable attachment bracket with the stainless steel cable clamp to the cable. Position the strength members between the plates. 4.9 Install the cable with the cable attachment plate in the closure ...

fibers underneath the splice holders and around the tabs (1) in the tray, first one side and then the other side. 5.4 Splicing cable 1 to 3. 5.5 Route first the incoming fiber from both sides into the groove behind the splice holder. 5.6 Install the splice protectors in the splice holder ...

5.11 Install splices in the SMOUV holder (the non-hinged side). 5.9 Use the fiber guiding pin to hold the tray in the open position. Remark: first use the SMOUV holders at the bottom side of the tray. When fully populated, use the SMOUV holders at the top side of the tray. B 48 splice tray Bottom, non-hinged ...

side. 5.15 Install the splices in the SMOUV holder. Route the fiber inside the tray and behind the SMOUV holder at the non-hinged side to the storage area. 5.16 Both sides. Bottom, hinged side Out In ...

5.20 Turn the splices 180° and install the splices in the SMOUV holder (hinged side). 5.17 Install the splices in the SMOUV holder (non hinged side). 5.18 Route the fiber from the SMOUV holder to the storage area over the edge of the cassette leaving no slack through the opening (1). 1 Top, non-hinged side Top, h ...

to the storage area. Repeat steps 5.18 en 5.19 to go to the storage area. 5.22 Both sides. 5.23 Install the splicing tray cover. 6.1.1 Remove 15 mm (0.6”) extra of the outer jacket as shown on the picture and leave the shield. Install the cable attachment bracket on the outer jacket. Plac ...

6.2 Grounding 6.2.1 Secure the grounding wire with the eyelet to the grounding bolt. 6.2.2 Connect the outer grounding wire onto the outer grounding feed through of the closure. 7.1 Insert the plugs between the outer strain relief in the unused cable ports. 7.2 Write down the installation date on the re-entry label in the cover of ...