Comtech EF Data LNAS Installation And Operation Manual

Text of Comtech EF Data LNAS Installation And Operation Manual

Comtech EF Data LNAS Low Noise Amplifier Series

Installation and Operation Manual Part Number MN-LNAS Revision 2 IMPORTANT NOTE: The information contained in this document supersedes all previously published information regarding this product. Product specifications are subject to change without prior notice.
Low Noise Amplifier Series Revision 2 MN-LNAS Copyright © 2021 Comtech EF Data. All rights reserved. Printed in the USA. Comtech EF Data, 2114 West 7th Street, Tempe, Arizona 85281 USA, 480.333.2200, FAX: 480.333.2161 Revision History Rev Date Description 0 - Initial Release. 1 2017 Unknown 2 Aug 2021 Updated formatting to incorporate current styles. Added X-band and Ka-band.
Low Noise Amplifier Series Revision 2 Table of Contents TOC-1 MN-LNAS TABLE OF CONTENTS PREFACE ..................................................................................................................................................... 1 About this Manual................................................................................................................................. 1 Conventions and References ....................................
Low Noise Amplifier Series Revision 2 Table of Contents TOC-2 MN-LNAS 4.4 Cables and Connectors .......................................................................................................... 4–2 4.5 Operating Requirements for Regulatory Compliance ......................................................... 4–2 CHAPTER 5. REDUNDANCY ............................................................................................................. 5�
Low Noise Amplifier Series Revision 2 Table of Contents TOC-3 MN-LNAS Acronym List Acronym Description CEFD Comtech EF Data GaA FET Gallium Arsenide Feed Effect Transistor HEMT High Electron Mobility Transistors LNA Low Noise Amplifier LNB Low-noise Block Down Converter MTBF Mean Time Between Failures VSAT Very Small Amplifier Terminals
Low Noise Amplifier Series Revision 2 Table of Contents TOC-4 MN-LNAS Units of Measurement Unit / Symbol Definition Ω Ohm A Ampere bps bits per second ˚C Celsius (degrees) Hz Hertz kHz kiloHertz dB decibel dBc Decibels relative to the carrier dBm Decibel-milliwatts ˚F Fahrenheit (degrees) GHz Gigahertz Kbps Kilobit per second kg kilogram ksps Kilosymbols per second lbs. pounds mA Milli-amp Mbps Megabit per second MHz Megahertz mm millimeter ms millisec
Low Noise Amplifier Series Revision 2 Preface Preface-1 MN-LNAS PREFACE About this Manual This manual provides installation and operation information for the Comtech EF Data Low Noise Amplifier (LNA) Series. This is a document intended for the persons responsible for the operation and maintenance of the LNAs. Conventions and References Patents and Trademarks See all of Comtech EF Data's Patents and Patents Pending at http://patents.comtechefdata.com. Comte
Low Noise Amplifier Series Revision 2 Preface Preface-2 MN-LNAS Examples of Multi-Hazard Notices Recommended Standard Designations The new designation of the Electronic Industries Association (EIA) supersedes the Recommended Standard (RS) designations. References to the old designations may be shown when depicting actual text (e.g., RS-232) displayed on the Unit. All other references in the manual refer to EIA designations. Carefully review the following i
Low Noise Amplifier Series Revision 2 Preface Preface-3 MN-LNAS Grounding PROPER GROUNDING PROTECTION IS REQUIRED: The installation instructions require that the integrity of the protective earth must be ensured, and that the equipment must be connected to the protective earth connection at all times. • In Finland: "Laite on liitettävä suojamaadoituskoskettimilla varustettuun pistorasiaan." • In Norway: “Apparatet må tilkoples jordet stikkontakt.�
Low Noise Amplifier Series Revision 2 Preface Preface-4 MN-LNAS International Symbols Symbol Definition Symbol Definition ~ Alternating Current Protective Earth Fuse Chassis Ground Operating Environment Maximum storage temperature allowed is -4 to +158°F (-20 to +70°C). Operation in vehicles or other transportable installations that are equipped to provide a stable environment is permitted. If such vehicles do not provide a stable environment, safety of
Low Noise Amplifier Series Revision 2 Preface Preface-5 MN-LNAS Additionally, the Revision 2 complied with these standards: • EN 61000-3-2 Harmonic Currents Emission • EN 61000-3-3 Voltage Fluctuations and Flicker • EN 61000-4-2 ESD Immunity • EN 61000-4-4 EFT Burst Immunity • EN 61000-4-5 Surge Immunity • EN 61000-4-6 RF Conducted Immunity • EN 61000-4-8 Power frequency Magnetic Field Immunity • EN 61000-4-9 Pulse Magnetic Field Immunity �
Low Noise Amplifier Series Revision 2 Preface Preface-6 MN-LNAS Product Support For all product support, please call: +1.240.243.1880 +1.866.472.3963 (toll free USA) Comtech EF Data Headquarters http://www.comtechefdata.com Comtech EF Data Corp. 2114 West 7th Street Tempe, Arizona USA 85281 +1.480.333.2200 Warranty Policy Comtech EF Data products are warranted against defects in material and workmanship for a specific period from the date of shipment, and
Low Noise Amplifier Series Revision 2 Preface Preface-7 MN-LNAS The warranty does not cover replacement or repair necessitated by loss or damage from any cause beyond the control of Comtech EF Data Corporation, such as lightning or other natural and weather-related events or wartime environments. The warranty does not cover any labor involved in the removal and or reinstallation of warranted equipment or parts on site, or any labor required to diagnose the
Low Noise Amplifier Series Revision 2 Introduction 1–1 MN-LNAS Chapter 1. INTRODUCTION 1.1 Introduction The Comtech EF Data (CEFD) Low Noise Amplifier (LNA) series includes LNA and redundant LNA/LB systems available in C-band (Figure 1-1), X-band (Figure 1-2), Ku-band (Figure 1-3), and Ka-band (Figure 1-4). They meet or exceed system requirements for commercial geosynchronous satellites worldwide. Their compact design and rugged construction make them id
Low Noise Amplifier Series Revision 2 Introduction 1–2 MN-LNAS Figure 1-3. Ku-band LNA Figure 1-4. Ka-band LNA 1.2 Technology The amplifiers incorporate both High Electron Mobility Transistors (HEMT) devices for low noise temperature performance and Gallium Arsenide Feed Effect Transistors (GaA FETs) devices for low intermodulation. The units use surface mounted components for robotic manufacturing techniques, thereby insuring maximum product consistency
Low Noise Amplifier Series Revision 2 Installation 2–1 MN-LNAS Chapter 2. INSTALLATION 2.1 Shipping Contents Inspect shipping containers for damage. If shipping containers are damaged, keep them until the contents of the shipment have been carefully inspected and checked for normal operation. The modulator and manual are packaged in pre-formed, reusable, cardboard cartons containing foam spacing for maximum shipping protection. CAUTION Do not use any cut
Low Noise Amplifier Series Revision 2 Installation 2–2 MN-LNAS 2.3 LNA Connector Pinouts The LNA can be supplied with the following connector configurations, depending on the model and options: • 4-pin • 6-pin Table 2-1. DC Power Connector, 4-Pin Pin # CLNA (Standard) XLNA (Standard) KLNA (Standard) Ka LNA (Standard) A +Vdc +Vdc +Vdc +Vdc B GND GND GND GND C Normally Open Normally Open Normally Open Normally Open D Fault Common Fault Common Fault Com

Comtech EF Data Amplifier Owners Instructions: