CommScope LSX Operation & User’s Manual

commscope.com 1RU LSX Splice Panel LSX-SPLCA01 Rev A © 2019 CommScope, Inc. Page 1 of 12 User Manual Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

TC-96254-IP Revision History Trademark Information CommScope (logo) and CommScope are trademarks of CommScope Inc. Related Publications Request at: http://www.commscope.com/SupportCenter Admonishments Safety admonishments warn of possible hazards to persons or equipment. An admonishment identifies a possible hazard and t ...

Figure 1. 1RU LSX Splice Panel Components • Front door-- protects the fibers and pigtails from normal activity near the splice panel. The front cover can be removed for convenience and protection during installation or other activity. The cover is removed by lifting it up to free it from its tab inserts. ...

TC-96254-IP • Splice drawer -- shown in both Figure 1 and in more detail in Figure 2 on Page 4. Figure 2. Splice Drawer Used in the 1RU LSX Panels 3 Specifications Table 1 lists specifications for the 1RU LSX Splice Panel. 4 Accessories The splice panel contains one drawer, which accommodates two CommScope single-fibe ...

Optional Interbay Management Panels (IMPs) are available for installation between frames. IMPs provide storage for patch cords between frames. Other accessories such as connector adapters, connector retainers, blank panels, and OSP and IFC clamp kits are available to complete the installation. 5 Installation ...

TC-96254-IP 6. Insert two #12-24 screws supplied through the mounting bracket at each side of the chassis and in the frame as shown in Figure 3. Figure 3. Mounting the Panel on a Frame 7. Install optional vertical cable guides or reinstall the removed guides. 8. Re-attach the front door. 5.3 Cable Routing Danger! Infrar ...

A cable clamp ships along with the panel. Cable installation is performed from the rear side of the splice panel. The OSP or IFC cables are routed to the back of the panel from either above or below the module. Prior to splicing, all cables (OSP and IFC) are routed to and secured to the side of the splice pa ...

TC-96254-IP Figure 5. Sheath Opening for OSP/IFC Cables Figure 6. Cable Clamp Components CABLE CLAMP CABLE SHEATH FIBERS SPLICES 0.75 IN. (1.9 CM) 26858-A 10 FT (3.05 M) RECOMMENDED 26749-A BASE SCREWS PANEL MOUNT PLATE GROMMET YOKE INSERT SCREWS BACK PLATE ...

Assemble the cable clamp components and attach the clamp to the side of the chassis. Some outside plant cables are constructed with a metallic strength member or a metallic inner sheath. Since OSP cables are exposed to electrical hazards, all metallic member OSP cables must be bonded to ground. Follow local ...

TC-96254-IP 5.5 Pigtails If used, Individual fibers with a factory installed connector on one end should be bundled together in groups (usually 12) and protected by a braided sleeve or loose tubing, and routed from a connector panel to the splice panel through the fiber pass-through holes at the top or bottom of the spl ...