Argus Security SG350-IS Instruction Manual

This wireless heat detector has been certified by Baseefa and has been awarded the ATEX Classification II 1 G ; Ex ia IIC T5 Ga –10˚C ≤ Ta ≤ +55˚C making it suitable for Category 1, 2 or 3 hazardous atmospheres with a maximum ambient temperature up to 55˚C. The product has been assessed an ...

When the Wirelex program or the translator module is waiting for this device to be linked, perform the following actions: 1) Check that the link switch is on the “ON” position 2) Extract the isolating tab from the back of the detector (picture 2) Device LED will indicate “operating mode” 3) Move the switch in position “1� ...

1) Cut off the small plastic lug on the plastic locking tab on the detector base (picture 4) 2) Install the detector onto the base 3) Check if the detector is effectively locked! To unlock the detector from the base: 1) Insert the tip of a small screwdriver into the side hole of the mounting base (picture 5) 2) ...

The device should be removed from its mounting base and transferred to the safe area before batteries are removed and replaced to enhance safe handling. When a low battery condition is indicated, both, main and secondary, batteries must be changed altogether. During this procedure the linking switch must NOT be touched at all! ...