MacDon M105 Manual 

Safety Product Modification 1. Remove decal MD #166472 (220 ft-lbs) from the right hand window of the windrower. Figure 1 – Windrower R/H Window Decal 2. Apply decal MD #166575 (170 ft-lbs) in the same location. Refer to the approximate dimensions in Figure 2. - 60 mm t ...

of decal MD #166472 (220 ft-lbs) on both left hand and right hand drive tires on both the inside and outside of the rims. Figure 3 – Drive Wheel Decal Location Figure 4 – Old Drive Wheel Decal 4. Place decal MD #166454 to the right of each MD #166584 decal as shown in Figure 5. Figure 5 – New Drive ...

Verify as follows: - Verify nut is L9 by ensuring it has 9 marks on one side (See Figure 6) - Verify washer is L9 by ensuring it has “L9” stamped on one side (see Figure 6) 6. Mark each wheel stud at the 12 o’clock position. Remove the old nuts ONE AT A TIME and replace with new washer and nut as per ...

PART NO DESCRIPTION QTY 136632 NUT - HEX L9 5/8-18-L9-ZP 16 136633 WASHER - FLAT HARDENED 5/8 IN. NOMINAL (L9) 16 169847 INSTRUCTION - SPM D61 SB1361 WHEEL NUTS & WASHERS 1 169570 INSTRUCTION - QUICK CARD M105 1 169565 INSTRUCTION - QUICK CARD M155 1 169475 INSTRUCTION - QUICK CARD M205 1 166575 DECAL - BOLT TORQUE 1 166584 DECAL - BOLT ...

169552_Supplement Revision D Page 3 of 8 7.4.2 Break-In Inspections ITEM SEE SECTION 1 Hour Check Drive Wheel Nut Torque - 170 ft·lbf (230 N·m). Repeat Checks Every Hour Until Torque Stabilizes. 7.12.1.2 At 5 Hours Check A/C Belt Tension. 7.8.10.1 Check Caster Wheel Nut Torque - 120 ft·lbf (163 N·m). 7.12.2.3 Check Caster Wheel ...

169552 / 169554 184 Revision D 7.12 WHEELS AND TIRES 7.12.1 Drive Wheels 7.12.1.1 Tire Inflation a. Visually check daily that tires have not lost pressure. Under-inflation of drive tires can cause side wall cracks. DANGER To avoid severe personal injury or death caused by machine runaway, shut off engine, and remove key before perfo ...

169552_Supplement Revision D Page 7 of 8 7.12.1.4 Drive Wheel Removal/Installation DANGER To avoid severe personal injury or death caused by machine runaway, shut off engine, and remove key before performing any of the following checks and/or adjustments. CAUTION Header MUST be removed, and NO weight box installed. Use a hydraulic j ...

Page 8 of 8 g. Install L9 nuts and L9 washers, and tighten to 170 ft·lbf (230 N·m) using the tightening sequence as shown above. IMPORTANT Verify nuts and washers are L9 by checking for markings (A) shown above. NOTE To avoid damage to wheel rims and studs, do NOT over-tighten wheel nuts. h. Repeat sequence three times. i. Lower w ...