LEGRAND C2G 29973 Manual 

(FR) (ES) Model 29973 EMEA Model 84309 ...

INTRODUCTION............................................................................................................... 4 PACKAGE CONTENTS ...................................................................................................... 4 OVERVIEW ................................................................................... ...

This solution delivers uncompressed 1080p full HD video and audio content to your existing HDTV set wirelessly. It operates the transmission in 5.1 GHz~ 5.9 GHz frequencies, and it can adjust its communication frequency automatically in case of interference from another RF system. With built-in ...

Rear of Wireless Transmitter REAR OF TRANSMITTER DESCRIPTION 7 Security Slot Attach a specialized security cable to the Hub’s Security Slot. 8 Power Input Connect 12V/1A DC universal power adapter to the power port. FRONT OF TRANSMITTER DESCRIPTION 1 Source Selection Switch Press switch to ...

10 HDMI Output Connect to HDTV set via an HDMI cable. ...

Connect a source device to the transmitter: 1. Connect the supplied power adapter to the DC IN port of the transmitter and a wall socket. Once the transmitter is connected to power the LED indicator lights on the source selection switch will be white. 2. Plug an HDMI cable or USB-C cable into transmitter’s corre ...

Hub will be turned on and link established automatically. When transmitter power is unplugged, receiver will enter Standby mode (POWER LED of receiver is lit in red) when link is dropped for over 10mins. 2. When receiver is in Standby mode (Receiver POWER LED is lit ...

Please refer to the below form containing detailed LED indicator and OSD description of transmitter / receiver: LED/OSD Behavior 1. The power LED will be solid white when the unit is powered on. 2. The source LED will be solid white when the source is selected. (The defa ...

received: 6.1 The TX unit will send the CEC message “TEXT VIEW ON” to turn on the TV set. 6.2 The TX unit will then send the CEC message “ACTIVE SOURCE” to switch to the selected source of the TV set. 7. If there is a signal to the source inp ...

1. Mark pilot holes by holding mounting plate (2) on wall. 2. Drill pilot holes from markings. 3. Insert the supplied anchors (3) into the wall. 4. Mount receiver (5) to mounting plate with the two supplied (4) screws. 5. Align the four holes that had been used for the pilot holes to the four anchors in the wall. ...