Graco SDX Series Instructions Manual

Text of Graco SDX Series Instructions Manual

SDX™ and XDX™

10/20 Series Hose Reels For dispensing air, water, antifreeze, windshield washer solvent, transmission fluid, and oil. Not for use with gasoline or diesel fuels. For professional use only. Not approved for use in European explosive atmosphere locations. Model: See page 3 for model information, including maximum working pressure and approvals. Related Manuals Important Safety Instructions Read all warnings and instr

SDX Series ............................................................3

XDX Series ............................................................4 Warnings ....................................................................5 Typical Installation.....................................................7 Overhead-Mounted Hose Reel .........................

(Part List page 31)

*Each SDX Model hose reel shown in the table is available in several colors. The last character of each Model No. indicates the hose reel color. For example: A = white, B = metallic blue, C = red, D = black, F = yellow. The SDX Series Models table uses the generic # symbol to represent the last character. For example, to order a white SDL56# model reel hose, the # symbol is replaced with “A” - SD

(Part List page 33)

*Each XDX or XNX™ Model hose reel shown in the table is available in several colors. The last character of each Model No. indicates the hose reel color. For example: A = white, B = metallic blue, D = Black, F = yellow. The XDX and XNX Models table uses the generic # symbol to represent the last character. For example, to order a white XDL2D# model reel hose, the # symbol is replaced with “A” - XDL2DA

The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The

exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of

EQUIPMENT MISUSE HAZARD

Misuse can cause death or serious injury. • Do not operate the unit when fatigued or under the influence of drugs or alcohol. • Do not exceed the maximum working pressure or temperature rating of the lowest rated system component. See Technical Specifications in all equipment manuals. • Use fluids and solvents that are compatible with equipment wetted parts. See Technical Specifications in all equipment manu

Overhead-Mounted Hose Reel

Key: A Main Air Supply Line B Pump Air Supply Line C Air Filter D Air Regulator E Bleed-type Master Air Valve (required) F Pump G Pump Grounding Wire (required) H Fluid Drain Valve (required) J Fluid Shutoff Valve K Fluid Line L Hose Inlet Kit M Hose Reel N Dispense Valve P Mounting Channel/Base FIG. 1: Typical Installation A B C D E F G H J K J L P M N

The typical installation shown in FIG. 1 is only a guide

for selecting and installing a hose reel system. The components shown are the minimum requirements for all systems. However, it is not an actual system design. Contact your Graco Distributor for assistance in designing a system to suit your needs. NOTE: The air and fluid accessories required for your pump must be properly sized to the pump. Refer to your pump manua

Pressure Relief Procedure

Follow the Pressure Relief Procedure whenever you see this symbol. 1. Turn off the power supply to the pump or close the upstream ball valve. 2. Trigger the dispense valve into a waste container to relieve pressure. 3. Open any bleed-type master air valves and fluid drain valves in the system. 4. Leave the drain valve open until ready to pressurize the system. NOTE: If you suspect that the dispense valve or

Graco Tools Owners Instructions: