Graco 245820 Manual 

Text of Graco 245820 Manual 

4000 psi (28 MPa, 280 bar) Maximum Working Pressure

Model 245820, Series C Ball and valve needle – abrasive material compatible Important Safety Instructions Read all warnings and instructions in this manual. Refer to your sprayer instruction manual for Pressure Relief, priming and spray instructions. Save these instructions. Contents Warnings . . . . . . . . . . . . . . . . . . .

The following warnings are for the setup, use, grounding, maintenance, and repair of this

equipment. The exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of

EQUIPMENT MISUSE HAZARD

Misuse can cause death or serious injury. • Always wear appropriate gloves, eye protection, and a respirator or mask when painting. • Do not operate or spray near children. Keep children away from equipment at all times. • Do not overreach or stand on an unstable support. Keep effective footing and balance at all times. • Stay alert and watch what you are doing. • Do not operate the unit when fatigued or

Pressure Relief Procedure

Follow the Pressure Relief Procedure whenever you see this symbol. 1. Turn sprayer OFF. 2. Engage the trigger lock. Always engage the trigger lock when sprayer is stopped to prevent the gun from being triggered accidentally. 3. Turn pressure control knob to lowest setting. 4. Put drain tube into a waste pail and turn Prime/Spray valve in PRIME position (drain) to relieve pressure. 5. Hold the gun firm

Connect Gun to Sprayer

Make sure sprayer is turned off and unplugged from power source. Refer to your sprayer instruction manual for priming and spray instructions. 1. Attach Graco airless hose to sprayer fluid outlet. 2. Attach other end of hose to gun swivel. Use two wrenches (one on the swivel and one on the hose), to tighten all connections securely. 3. Refer to sprayer instruction manual for priming instructions. Installing T

Unlock trigger lock.

2. Be sure the arrow shaped tip faces forward (spray). 3. Hold gun perpendicular and approximately 12-inches (30 cm) from surface. Move gun first, then pull gun trigger to spray a test pattern. 4. Slowly increase pump pressure until coverage is uniform and even (see sprayer instruction manual for additional information). 5. Periodically inspect gun handle vent for fluid buildup, this could indicate an in

Clear Tip Clog

In the event that particles or debris clog the spray tip, this sprayer is designed with a reversible spray tip that quickly and easily clears the particles without disassembling the sprayer. 1. Engage trigger lock. Rotate spray tip to unclog position. Disengage trigger lock. Trigger gun at waste area to clear clog. UNCLOG NOTE: If spray tip is difficult to rotate when turning to the unclog position perform, Pressure Relie

Perform Pressure Relief Procedure,

page 4, and engage trigger lock. 2. When removing gun from hose, hold hex end of fluid tube assembly (19) securely to avoid loosening fluid tube from gun body. 3. If fluid continues to flow after trigger is released, gun valve may need adjustment, be obstructed or damaged, or valve stem (24), seat (26), or seal (3) may be worn or damaged. a. Adjust valve or spring tension as instructed on page 8

Graco Tools Owners Instructions: