Bante Instruments PHscan20 Instruction Manual
Text of the manual
Bante is committed to the reduction and eventual elimination of all hazardous
substances in both the manufacturing process and finished products we supply.
We have an active manufacturing and procurement program to minimize and
eliminate the use of harmful heavy metals such as cadmium, lead, mercury and
the like.
New technologies and design parameters are a
The tester includes 3 multifunction keys, names and symbols describe function
key controls.
The tester is equipped with a clear LCD display used to show measured values,
mode indicators and unit indicators.
Thank you for selecting the PHscan20 pocket pH tester. This manual provides
a step-by-step guide to help you operate t
— Press MEAS key to turn on the tester, the display shows measured values.
—
—
Preparation of pH Standard Buffer Solutions
The tester is packaged with three pH buffer packets required for calibration.
Open the pH7.00 buffer packet, place the powder into a 250ml volumetric
Press ENTER key to confirm, the tester goes to calibration point selection
mode, the display shows “2/CAL” (2
4. Press CAL key to select the number of calibration points.
Press ENTER key to confirm, the
3.
5.
tester shows “YES/HOLD”
the auto-hold function is enabled.
— If the auto-hold function is
POCKET PH TESTER
allows up to 3 points calibration.
tester can
—
—
—
Press CAL key the tester shows “pH7.00/CAL1”(or “pH6.86/CAL1”).
4. Dip the pH electrode into the pH7.00 (or pH6.86) standard buffer solution,
the end of the electrode must be completely immersed into the calibration
solution. Stir the tes
Rinse the electrode with distilled water,
ait for the measured value to stabilize, the
display shows electrode slope and “END”. The tester returns to the pH
measurement mode. Calibration is completed.
EXIT THE CALIBRATION:
During the calibration, if you want to exit calibration mode, press MEAS key.
The tester will i
1 to 3 points
Calibration Solutions
USA (pH4.01, 7.00, 10.01)
NIST (pH4.01, 6.86, 9.18)
Temperature Compensation
o
o
0~60 C, 32~140 F, Automatic
Auto-Off
After 8 minutes from last key press
Operating Temperature
o
o
0~60 C, 32~140 F
LCD Display
Custom LCD
Power Requirement
2
1.5V “
×
AAA” Batteries
Weight
100 grams
Dimensi