Halytech microSpider2 Industrial Quick Start Manual

Text of the manual

ABN 51 094 853 068

Tel: (02) 8814-5235 Email: [email protected] PO Box 6983 Baulkham Hills Business Centre NSW 2153 microSpider2 Industrial Quick Start Guide This guide is not a replacement for the User Manual. Please refer to the complete microSpider2 manual available from our website: www.halytech.com.au Once on our website go to Products�

Installing a SIM card

You need a SIM card to receive automatic e-mail and/or FTP reports from your microSpider2. Halytech can provide fully functioning SIM cards for you. If you want to source your own SIM card, contact your preferred mobile phone carrier and ensure that the SIM card is provisioned with a plan enabling internet access. microSpider2 units are

Connecting Internal 9V “Backup” Battery (Optional)

The internal 9V battery serves as a ‘backup’ for microSpider2 RAM. RAM is used to maintain information such as counters, alarm state, when the modem should perform retries, and other current system information. Should microSpider2 lose power entirely, RAM will be lost, and on reboot the information l

Connect the antenna lead by screwing the flying lead connector onto the gold antenna “ANT” connector –

finger tight only Antenna Connector Connecting Power Connect a 16V – 24V DC, 2A minimum current Power Supply or a 12V Solar Panel to the “Charger” connector. Please observe the correct polarity. Optional - connect

FRONT I/O CONNECTORs (from left to right in previous image)

PIN NAME FUNCTION COMMENT D1 DIN1 SWITCH 1 / COUNTER 1 / QUADRATURE 1A Active is short to GROUND A1 AIN1 ANALOGUE 1 0 – 2.4V or 4-20 mA range - GND GROUND D2 DIN2 SWITCH 2 / COUNTER 2 / QUADRATURE 1B Active is short to GROUND A2 AIN2 ANALOGUE 2 0 – 2.4V or 4-20 mA range - GND GROUND PO PWR OUT S

Some usage scenarios of the microSpider2 I/O connectors are outlined below:

1. Using the connectors provided, connect Inputs as per manual a. Switch, counter, quadrature and tamper inputs - connected directly to appropriate input and GROUND. b. 4-20mA – connect directly between an available analogue input and GROUND. External resistors are NOT required c.

Connecting the microSpider2 Industrial to your PC

1. Disconnect your computer from your network and turn it on. 2. Connect one end of the red crossover LAN cable into the “LAN” connector of the microSpider2. 3. Connect one end of the white USB cable into the “USB” connector of the microSpider2. 4. Connect the other end of the LAN cable into your comp

Configuring your microSpider2

Continuing on from the previous section, follow these steps to begin configuring your microSpider2: Once you have logged in, select “Change Setup” and 1. Go to the "Change Setup" page 2. Set location – to your site name 3. Set date and time 4. Set username and password for security 5. Configure and name the Inputs as requi

More Halytech Data Loggers Owners Instructions: