Stack-On TD14-22-GP-E-S Instructions Manual

Text of Stack-On TD14-22-GP-E-S Instructions Manual

• Keep keys and combination in a secure

place away from children. • Do not store back up key or this document in the safe. • NOTE: Stack-On is not responsible for any cost incurred if the safe is replaced due to a flood. • Do not store electronic media, computer disks, audio-visual media or photographic negatives in this safe. This material will not survive the rated internal temperature of the safe. This material may be damaged or destroye

You must first install the battery which is located in

the front protective styrofoam. NOTE: When changing the battery, always hold the battery connecting cap while disconnecting or attaching the battery. Do not pull on the wires. Doing this could cause the power supply to become disconnected from the lock. This safe uses one 9V alkaline battery. Under normal use, batteries will last about 1 year. When the battery is low and you pr

ENTERING YOUR SECURITY CODE

ELECTRONIC LOCK After installing the battery, to open the electronic lock the first time, first press any key to activate the keypad, then press the following numbers/symbols on the electronic keypad in this order: 1 - 5 - 9 - #. These numbers are preset. NOTE: You should change the entry code as soon as possible after opening the safe to insure proper security. After you have entered the factory code, you will need to turn the

LOCKING THE SAFE

TURNING THE KEYPAD SOUND OFF/ON You can turn off the "Beep" sound of the keypad by entering the code 6 3 3. To turn the "Beep" sound on, enter the code 6 6. To lock the safe, close the door and rotate the handle counter clockwise until it stops. If the handle is not turned until it stops, the locking mechanism will not lock. NOTE ON LOCKING THE SAFE: Because the locking mechanism is deactivated for approximately 3 to 6 s

SECURING THE SAFE

IMPORTANT: When you drill out the fire resistant caulking from the mounting hole you must mount the safe to the floor using the lag bolts and gasket washers. Failure to do so will void the fire rating and waterproof rating. You must remove the safe from the skid/legs and place the safe on the floor. Failure to do so will void the fire and waterproof ratings. The safe must be fastened to the floor using the lag bolts and gasket washers

STACK-ON PRODUCTS CO.

P.O. BOX 489, WAUCONDA, IL 60084 IMPORTANT Keep keys and combination number in a secure place, away from children. Keep this record of your key number, serial number and combination in a secure place separate from your safe. To order a replacement key set, follow the instructions on the attached form. The shelving can be installed by locating the shelf clips to the desired locations and setting the shelf in place. SHELVING NOTE: Th

“This is not a Registration Form”

Verification of ownership is required in order to receive replacement key for your security product. In order to receive a replacement key to your security product: 1. Complete the following form and send to Stack-On Products. 2. Send a copy of your valid driver’s license along with the form. 3. Send a copy of the receipt showing the original purchase. 4. Security product owner must sign form. 5. Owner�

Stack-On Safes Owners Instructions: