Premier Mounts PSD-TS Installation Manual

Text of Premier Mounts PSD-TS Installation Manual

PLASMA STAND MODEL

I N S T A L L A T I O N M A N U A L 3130 E. Miraloma Ave. Anaheim, CA 92806 Phone: 800 368-9700 Fax: 800 832-4888 www.mounts.com PREMIER MOUNTS ©2004/ REV 00

- 2 -

o Safety & precautions o Floor stand diagrams o Parts List o (Optional) Accessories o Installing the Posts to the base o Securing the adapter o Installing the back plates o (Optional) Shelf o (Optional) Magnetic covers o Checking for proper safety and security When combined with a mount, our floor stand allows you to place a flat panel display in a horizontal or vertical position (with the PSM mount only). The floor stand can be configured for single

- 3 -

The entire installation instructions should be fully read and understood, including all of the safety symbols and safety precautions, before beginning installation. The installation instructions should be read, understood and followed to prevent personal injury or property damage. Keep these installation instructions in an easily accessible location for future reference. Indicates that the power plug is to be disconnected from the power outlet. Safet

- 4 -

R33.89 R33.89 R24.39 19.68 14.75 29.50 .250 Ø.38 (X5) 27.22 R1.00 Ø.38 35.50 R24.39 60" 72" 84" Our PSD-TS floor stands will mate directly with our CTM and PSM series mounts. Floor stand diagrams PSD-TS BASE MATERIAL: ¼" Steel plate COLOR: Silver, Sinterflex gray MATERIAL: 2" (dia) Posts COLOR: Chrome or Black OPTIONAL POST SIZES 60" Height posts 72" Height posts 84" Height posts NOTE: Use the four .38" diameter securing points to secure the base

- 5 -

o Phillips screwdriver, used on the PSM-Series and (optional) accessory shelf o 17 (mm) Socket head o Wrench QTY SIZE DESCRIPTION 1 ƒ BASE 1 ƒ PSD-SPA ADAPTER 1 ƒ 5/32" ALLEN WRENCH 2 M8 x 10 SOCKET HEAD SCREWS 4 M10 x 12 HEX HEAD SCREWS/ FLAT WASHERS 1 ƒ M10 ALLEN WRENCH Parts List Accessories (Optional) TOOLS & SUPPLY NEEDED EQUIPMENT SHELF MATERIAL: 12 (GA) CRS MAGNETIC CABLE COVERS MATERIAL: 18 (GA) CRS PSD-SHA: Sinterflex

- 6 -

(2) Inner tube clamps (2) 2" Tubes Allen wrench PSD-TS Base Installing the posts to the base The PSM and CTM series mount is required to complete the PSD-CS system. Refer to its installation instructions to install the flat plasma display bracket. The location of the stand must be a flat surface. Remove the stand out of the box and check for all proper hardware, if missing any hardware please call Premier Mounts. Insert the tubes over the base column

- 7 -

(2) 2" Tubes PSD-SPA adapter (2) M8 x 10 Hex screws Allen wrench Installing the back plate to the adapter Install the PSD-SPA (stand adapter) through the top of the tubes and secure it to your desired height with the two (2) M8 x 10 Allen screws (supplied) found on the back of the adapter. Use the 5/32" allen wrench (supplied) to secure the adapter to the posts. See figure 2. NOTE: The back plate will vary depending on the system ordered. There are t

Premier Mounts Racks & Stands Owners Instructions: