Xpresskit RFLMIT3 Quick Start Manual

Text of Xpresskit RFLMIT3 Quick Start Manual

† Chrysler, Jeep, Dodge, Mitsubishi, GM, Hyundai and KIA are registered trademarks and property of their respective companies.

RFLCHGM (Black shrink) RF immobilizer bypass for most Chrysler vehicles built after 2004 as well as GM vehicles equipped with the PK3+ OTHER AVAILABLE RFLOOP RFLKIA2 (Yellow shrink) RFLUB (Blue shrink) RFLMIT3 (Green shrink) RF immobilizer bypass for most Mitsubishi models from 2004 & up RF immobilizer bypass for Kia Amanti

RF immobilizer bypass for most

Mitsubishi models from 2004 & up When the programming tool will prompt to insert the new key and turn the ignition ON, put the transponder part of the RFLMIT3 close to ignition and power-up the ignition wire with a jumper wire. Ignition Jumper wire Power 2 Once the programming tool asks you to remove the new programmed key, remove the jumper wire from ignition and remove the RFLMIT3 from the ignition switch. Ignition

Xpresskit RFLMIT3 Loop including a

Mitsubishi transponder A) P ound the vehicle's ignition cylinder as shown. B) Plug the 2 pin loop antenna ring connector into the 2 pin connector of the module. lace the loop antenna ring ar Note Move antenna loop as close to the front of the ignition cylinder (factory receiver ring) as possible. Test before finishing the installation & closing the cover. To complete the installation, install the RFLMIT3 around the ignition. RFLMIT

LIMITED ONE-YEAR CONSUMER WARRANTY

For a period of ONE YEAR from the date of purchase of a Directed Electronics remote start or security product, Directed Electronics. (“DIRECTED”) promises to the original purchaser, to repair or replace with a comparable reconditioned piece, the security or remote start accessory piece (hereinafter the “Part”), which proves to be defective in workmanship or material under normal use, provided the following conditi

Xpresskit Automobile Accessories Owners Instructions: