Scilogex SCI-L180-E Operation & User’s Manual

Text of Scilogex SCI-L180-E Operation & User’s Manual

Linear Shaker & Orbital Shaker
User Manual SCI-L180-E Analog Linear Shaker SCI-O180-E Analog Orbital Shaker SCI-L180-S LED Digital Linear Shaker SCI-O180-S LED Digital Orbital Shaker Please read the User Manual carefully before use, and follow all operating and safety instructions! Technical specifications and outline are subject to change without prior not
Contents Preface  ................................................................................  1 Service  ................................................................................  1 Warranty  .............................................................................  1 1. Safety Instructions  ....................................
Welcome to the “Linear Shaker & Orbital Shaker User
Manual”. Users should read this manual carefully, follow the instructions and procedures, and beware of all the cautions when using this instrument. Service When help needed, you can always contact the service department of manufacturer for technical support in the following ways: SCILOGEX, LL
1. Safety Instructions
Warning! • Read the operating instructions carefully before use. • Ensure that only trained staff works with the instrument. Protective ground contact! • Ensure the socket must be grounded (protective ground contact) before use. • When working wear personal safety guards to avoid the risk of: -­‐ Splashing liquids -­‐
2. Proper Use
The instrument is designed for mixing sticky substance in schools, laboratories or factories. It can be installed on a variety of impeller, for different viscosity of the medium. This instrument is not suitable for using in residential areas or other constraints mentioned in Chapter 1. Do not use the accessories recommended by the manufacture
4.1 Analog Model
Shaking table Speed control knob Power light Power switch Power interface Screws Items Descriptions Speed control knob Set target speed. Power switch Switch ON/OFF instrument. Power interface Connect the power cable Power light Green LED display light Screw Install the platform.
4.2 LED Digital Model
Shaking table Parameter adjusting knob Mode switch button Speed display Time display Power switch Power interface Screws Items Default settings Mode switch button Mode Shift speed and time setup mode Parameter adjusting knob Set speed and time by rotating the knob. Push on/off to start/stop rotating function. Speed display Display the
5.1 Analog Model
• Place the instrument in safe and stable surface, ensure the required operating voltage and power supply voltage matched. • Connect the power cable. • Install the platform. • Switch ON the instrument. • Rotate the speed control knob clockwise to set target speed, and the shaking function will be switched on. • Rot
The speed value can be altered during shaking.
6. Faults • When switched ON, the instrument does not work n Check whether the power cable is connected • Motor  speed  cannot  reach  set  value n Check whether it is overloaded 7. Maintenance and Cleaning • Proper maintenance can keep instrument working properly and lengthen its l
8. Associated standards and regulations
Construction in accordance with the following safety standards: EN 61010-1 UL 3101-1 CAN/CSA C22.2(1010-1) EN 61010-2-10 Construction in accordance with the following EMC standards: EN 61326-1 Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to op

Scilogex Laboratory Equipment Owners Instructions: