KUDOS Original6 Installation Instructions

Pozi-head Screwdriver Flat-head Screwdriver 3mm Allen Key - supplied Cutting Pliers Junior Hacksaw Clear Silicone Sealant 7mm Masonry Drill Bit Drill (Battery or Mains) Spirit Level Tape Measure Marking Paste (Shoe Polish) STRAIGHT SLIDING DOOR 1400 & 1500mm Please read these instructions throughout before installing as incorrect fitting will invalidate the guarantee. If you are unsure about these instructions please contact Kudos Shower Products 01539 564040. HEALTH & SAFETY WARNING DUE TO THE WEIGHT & SIZE OF THE GLASS PANEL(s) A MINIMUM OF TWO PERSONS ARE REQUIRED TO MOVE AND INSTALL THIS ENCLOSURE For the wall post and fixings us ...

THIS FACE TO OUTSIDE THIS FACE TO OUTSIDE Parts List Installation Pack Installation Steps 2050 & 840mm x PlexF05 Glazing Wedge Seal Important IF YOU ARE INSTALLING A SIDE PANEL TOGETHER WITH THIS DOOR, PLEASE READ THESE INSTRUCTIONS IN CONJUNCTION WITH THE INSTRUCTIONS FOR THE SIDE PANEL PROVIDED IN THE SIDE PANEL PACKING. 1 x Fixed Glass Panel 1 x Door Glass Assembly 1 x Fixed Panel Wall Post 1 x Door Panel Wall Post 1 x Rail Left 1 x Rail Right Step 1 - Determine Opening Side 1. Stand the ‘Door Glass Assembly’ upright, leaning against a wall ensuring all contact corners are protected. Determine if the shower enclosure is to be o ...

Step 7 - Trim Excess Seal 1.During the manufacturing process the seals on each side of the frame are often left ‘long’ to allow for expansion and contraction during transit. Ensure the seals are sitting flush with the bottom of the frame on each side. 2.Using cutting pliers, trim the seals on each side flush with the top of the frame. 2. Using a flat headed screwdriver, adjust the six nylon adjustment screws, three down each side, in an anti-clockwise direction, until the frame has expanded and is only slightly wedged. Try to adjust each side equally, to achieve equal spacings down each side of the frame . Step 8 - Adjust Height 1 ...

Step 14 - Fixed Glass Panel Step 15 - Fit Seal to Fixed Glass Panel Step 10 - Drill Mounting Holes & Insert Wall Plugs 1. Remove the frame from the recess, loosening the adjustment screws along each side if required (do not adjust the bottom height adjustment screws). Placing safely off to one-side. 2. Using a 7mm masonry drill bit and drill (or appropriate drill bit if drilling tiles), drill six holes using the ‘spot’ marks from step 8, each hole should be 45mm in depth. 3. Insert the six ‘6mm Wall Plugs’ into the six holes. Step 11 - Fitting the Frame 1. Insert the frame back into position, tighten the adjustment screws once ...

Step 17 - Adjust Glass IMPORTANT: You must ensure that the bottom of the glass door runs completely parallel with the top surface of the bottom rail, if not you need to adjust the enclosure ensuring everything is level. Failure to follow this instruction will cause the bottom seal to tear prematurely and invalidate the seals 2 year guarantee. 1.Looking from the outside of the enclosure, slide the door into the closed position, with the glass pushed up against the seal on the wall post. Check the door glass is level with the wall post down the entirety of its edge. 2.If there is an uneven gap, the glass in the door can be adjusted ei ...