Xantech 480-85 Installation Instructions

Text of Xantech 480-85 Installation Instructions

DINKY LINK™ “CFL & LCD FRIENDLY” INFRARED RECEIVER

WITH ADJUSTABLE CARRIER FREQUENCY TABLE OF CONTENTS Table of contents...............................................................................................................................................1 Introduction..........................................................................................................................................

Xantech 480-85 © 2005 Xantech Corporation

SPECIFICATIONS • IR carrier input frequency reception range: 30 to 60 kHz. • IR reception range: Up to 50 feet on axis (range depends on device being controlled and levels of IR or EM interference). • Reception angle: 55 degrees off axis with 50% range reduction. • Power: 12 volts DC @ 20 mA. • 781RG Power Supply (not included) powers up to 7 480-85's. • Maximum current output: 100 mA peak. • Ca

© 2004 Xantech Corporation

APPLICATION WIRING A typical system, with a 480-85, 781RG Power Supply and 283M Emitter plugged into a 789-44 Connecting Block, is shown in Figure 2: 1. Run the 7 foot ribbon wire of the Dinky Link™ back to the home run location or where ever the Connecting Block will be placed. Note: If the connecting block must be placed at a distance greater than 7 feet, attach the tinned ends of the Dinky Link™ cable
© 2005 Xantech Corporation 2. If it does not work or has poor range (less than 15 feet), determine the IR carrier frequency of the product you wish to control. Contact the manufacturer of the product, if necessary, to determine this frequency. 3. Using a small blade type screwdriver (3/32" blade width max.), rotate the adjustment shaft slightly either Clockwise for Carrier Frequencies less than 38kHz or Counter Clockwise for Carrier Fr

Xantech Receiver Owners Instructions: