Xantech RGC11 Installation Instructions Manual

Text of Xantech RGC11 Installation Instructions Manual

Remote Control Switchers

The RGC11, Fig. 1, is an IR Remote Controlled Line Level Gain Control Module. It permits line level gain control of audio power amplifiers (instead of at speaker level), in multiroom installations, when highest sound quality is desired. It may also be used in any application where IR remote control of gain is desired, such as between the pre-out and main-in jacks of integrated amplifiers or receivers that were built without

RC68+ or (RC68) PROGRAMMER / REMOTE CONTROL

The RC68+ Programmer (available separately) contains all the commands necessary to operate the RGC11. • You will need it to program universal learning devices such as the Xantech URC-1 learning remote, the Xantech Smart Pads, the 590 Programmable Controller, the 710 Fone Link, etc., with commands that operate the RGC11. • NOTE: The RC68+ codes operate several other Xantech models as well, such as the RS
Remote Control Switchers INSTALLATION – COMMON IR BUS SYSTEMS Fig. 3 illustrates a typical installation using three RGC11's along with other Xantech products in a 4-room common IR bus system. The principles shown should be used as a guide when planning your own specific installations. It is configured as follows: 1. For simplicity, only three RGC11's are shown. A practical limit would be six RGC11's "daisy-chained" using the "LOOP THROUG H" jacks

 4 LEFT RIGHT IR CONFIRM LEFT RIGHT OUTPUT LOOP THROUGH INPUT RGC11 REMOTE GAIN CONTROL MODULE IR IN G 15VAC V V LEFT RIGHT IR CONFIRM LEFT RIGHT OUTPUT LOOP THROUGH INPUT RGC11 REMOTE GAIN CONTROL MODULE IR IN G 15VAC V V LEFT RIGHT IR CONFIRM LEFT RIGHT OUTPUT LOOP THROUGH INPUT RGC11 REMOTE GAIN CONTROL MODULE IR IN G 15VAC V V R L + – + – CD Changer ROOM 4 ROOM 3 XANTECH S-62/64/66 Wall Speakers ROOM 2 R L + – + – 780-80 "J
Remote Control Switchers INSTALLATION – DEDICATED IR BUS SYSTEMS Fig. 4 illustrates an installation where each remote room has a Dedicated IR Bus going to the RGC11 that controls it. The IR bus is not connected in common as it is in Fig. 3. This eliminates the need for dedicated remotes, allowing you to carry the same remote(s) from room-to-room. It is configured as follows: 1. Again, for simplicity, only three RGC11's are shown. A practical li

L O G I C P O L A R I T Y

S E L E C T O R A B CONTROL INPUTS 1 2 3
Remote Control Switchers CD Changer CONTROL OUTPUTS L O G I C P O L A R I T Y S E L E C T O R A B CONTROL INPUTS 1 2 3 4 5 1 2 3 4 5 6 7 8 9 1 0 ON 793-10 SERIAL CONTROL COMBINER CONTROL OUTPUTS L O G I C P O L A R I T Y S E L E C T O R A B CONTROL INPUTS 1 2 3 4 5 1 2 3 4 5 6 7 8 9 1 0 ON 793-10 SERIAL CONTROL COMBINER 789-44 Connecting Block 793-00 Serial Combiner 793

Xantech Receiver Owners Instructions: