Emerson PACSystems RX3i Important Product Information

Text of the manual

IMPORTANT PRODUCT INFORMATION

GFK-2573Z Sep 2020 PACSystems™ RX3i PROFINET Controller IC695PNC001-BDBD1 2 Firmware Version 3.16 1 Includes conformal coat and low temperature module variants, if available. 2 The last two characters of the catalog number suffix may not increment with every firmware release beginning with IC695PNC001-BCBD Release 3.15.

Warnings and Caution Notes as Used in this Publication

WARNING Warning notices are used in this publication to emphasize that hazardous voltages, currents, temperatures, or other conditions that could cause personal injury exist in this equipment or may be associated with its use. In situations where inattention could cause either perso

The PACSystems™ RX3i PROFINET Controller module, IC695PNC001 or PNC001, connects a PACSystems RX3i

controller to a high-speed PROFINET local area network. It enables the RX3i controller to communicate with I/O devices on the LAN. The PNC001 provides all the functions, services, and protocols required for certification as a PRO

PROFINET Version 2.2 General Class A I/O-Controller.

Redundantly controlled operation conforms to PROFINET V2.3 Type S-2 System Redundancy. RX3i CPU Compatibility See Functional Compatibility section. Power Requirements PNC001-Ax PNC001-Bxxx 3.3 Vdc: 0.6 A with no SFP devices 1.3 A maximum (two SFP

EMC Installation Requirements

To meet EN 55011 and FCC Class A radiated emissions, the Control system in which the IC695PNC001 module is used shall be mounted in a metal enclosure when three or more IC695PNC001 modules are used. All surfaces of the enclosure must be adequately grounded to adjacent surfaces to provide electrical conductiv

ATEX Zone 2

This module must be mounted in an enclosure certified in accordance with EN60079-15 for use in Zone 2, Group IIC and rated IP54. The enclosure shall only be able to be opened with the use of a tool. Status Reporting The PNC001 provides 32 bits of status information to a configured location in the RX3i CPU’s reference memory

LEDs on the PROFINET Controller Module

The table below summarizes LED functions. Note that there are differences between the -Ax version and the -Bxxx version. For detailed information refer to Installation and Diagnostics in PACSystems RX3i PROFINET I/O Controller Manual, GFK-2571K or later. OK Indicates whether the module is able to pe

Before installing and operating the PNC001, refer to PACSystems RX3i PROFINET I/O Controller Manual, GFK-2571 for

detailed information. Installation and initial startup procedures for the PNC001 include the following steps: 1. Pre-Installation check 2. Installing the PNC001 in an RX3i backplane The PNC001 must be installed i

If the surrounding air operating temperature of the PNC001 is greater than 40C, SFP devices could

have operating temperatures over 70 °C (158 °F). Under these conditions, for your safety, do not use bare hands to remove an SFP device from the SFP cage. Use protective gloves or a tool (needle- nose pliers) to avoid handling the hot S

Supports the Remote Get HART Device Information COMMREQ. Information from a

HART device connected to an RX3i Analog Module in an IC695PNS001 RX3i PROFINET Scanner may be read into the user application using the Remote Get HART Device Information COMMREQ. IC695PNC001-AL

Other Controller Manuals