Sundstrom SR 900 Operation & User’s Manual

Operation, Maintenance and Training Manual Sundstrom Safety Inc. 143 Maple St. Warwick, RI 02888 Office: 1-401-434-7300 Toll Free: 1-877-SUNDSTROM Fax: 1-401-434-8300 [email protected] www.srsafety.com SR 900 APR Half Mask Sundström Half-Mask Air-Purifying Respirator Demi-masque Mascarilla ...

ID-tag ................................................................... 47 EN Veuillez lire et conserver ces consignes ............ 17 Étiquette ID ......................................................... 47 FR Lea y guarde estas instrucciones ....................... 32 Etiqueta de identificación .................................. 47 ES ...

I Introduction II Warnings and Cautions III Respirator Use Limitations IV Configuration and selection guide V User Training and Instructions 1. Why Use Respiratory Protection 2. Changing the Protective Elements 3. Inspection Prior to Use 4. Donning/Use/Doffing Instructions VI Maintenance, Cleaning and Storage VII Warranty VIII NIOSH Labels I. INTRODUCTION The Sundström Safety SR 900 Half mask Air-purifying Respirator (A ...

This product should not be used without a thorough understanding of all the components and their purpose. Read this entire booklet carefully and refer to it wherever a question arises. You must also satisfactorily complete all federal and local training requirements before entering a hazardous atmosphere. Special attention must be paid to all the Warnings, Cautions and Notes used in this manual. Notes, Cautions and Warnings ar ...

tridges and canisters are replaced before breakthrough occurs. • Failure to properly use and maintain this product could result in injury or death. • The Occupational Safety and Health Administration regulations require gas-proof goggles to be worn with this respirator when used against formaldehyde. • Follow the manufacturer’s User’s Instructions ...

contaminant(s) and the activity of the respirator wearer. Replace the air-purifying elements when you detect any indication of damage or loss of effectiveness, or when instructed by competent authority. 11. When used for protection against Isocyanates use appropriate eye and face protection in order to avoid eye and skin irritation. 12. If you exp ...

Order Number SR 900, Small H01-3021 SR 900, Medium H01-3121 SR 900, Large H01-3221 FILTER/CARTRIDGES/PRE-FILTER OV Cartridge, SR 218-6 H02-2121 CL/HC/SD/FM Cartridge, SR 231 H02-3621 OV/SD/CL/HC/HF Cartridge, SR 232 H02-3721 AM/MA Cartridge, SR 229 H02-4321 P100 filter SR 510 H02-1321 Pre-filter, SR 221 H02-0121 SPARE PARTS Single Strap Head Harness R01-3001 Cradle Head Harness R01-3002 Filter Attachment R01-3003 Gasket R01-3004 Val ...

This process continues until the sorbent becomes saturated and allows the contaminant to ‘break- through’ the cartridge and to be detected by the user. Each chemical cartridge is designed to provide protection only from specific contaminants. Replace chemical cartridges immediately when you detect any contaminants inside the respirat ...

Kidneys, liver, brain CANCER PERMANENT DISABILITY asthma, silicosis, asbestosis or emphysema or at worst DEATH WARNING Do not enter a hazardous or unknown atmosphere without asking your safety professional what type of protection is required. Use all the protective equipment and wear it properly. At the first sign of trouble exit the hazardous area, seek help and report the problem to the proper authority. B. What is a half mask r ...

BLACK Organic Vapors YELLOW Organic Vapors, Sulfur Dioxide, Chlorine, Hydrogen Chloride and Hydrogen Fluoride WHITE Chlorine, Hydrogen Chloride, Sulfur Dioxide and Formaldehyde GREEN Ammonia and Methylamine The NIOSH/DHHS approval label for each product lists limitations and requirements. All current NIOSH/ DHHS labels can be found in the respirator box printed on a sheet titled Section “VIII NIOSH/DHHS LABELS� ...

enter the respirator. As the filter loads up with these particulates inhalation becomes uncomfortable. When you detect increased inhalation resistance, leave the contaminated area and change the pre-filter, or if necessary, the protective filter. Pre-filter – This inexpensive nuisance pre-filter is used with a cartridge or P100 filter. When b ...

1) Insert one part of the large lip of the protective element into the filter attachment flange. The arrows on the label point to – “this side toward face”. 2) Use your finger to pull the lip of the attachment flange around the element until the entire car- tridge or P100 filter lip is seated inside the filter attachment. 3) Squeeze the top edge of the element and the bottom edge of the respira ...

A. Pre-donning checks Before donning the respirator always perform the following checks. 1) Check that the respirator is the correct size. 2) Ensure that the respirator is clean and dry. 3) Check the respirator, valves and harness for wear, cuts, cracks, missing parts, and other defects. 4) Check that the appropriate filter or combination is installed properly. 5) Check that the use-by date has not been passed. The use-by date ...

WARNING A proper fit check must be completed successfully each time the respirator is worn. Failure to achieve a proper face-to-respirator seal before you enter a hazardous atmosphere may result in little or no respiratory protection. Negative Fit Check 1) Install a protective element. 2) Snap the pre-filter holder onto the protective element. 3) Donning the respirator. 4) Place the palm of your hand lightly over the hole on the pre-filter ...

CAUTION A dirty respirator causes reduced protection. A written program for cleaning and sanitizing should be established and followed. This program should include all federal and local requirements. Before use After use Every year Visual check Fit check Cleaning Change membrane Change harness Change gasket A. Disassembly 1) Remove all protective elements. 2) Remove the covers from the exhalation valves and remove t ...

2) Fasten the filter attachment to the respiraor body by aligning the bayonet coupling and turning it counterclockwise a 1/4 a lap until it snaps on. 3) Check the edge of the inhalation valve. Gently stretch the flap until it slips over the stud. 4) Push each exhalation valve flap on the valve stud until it ‘pops’. 5) Snap on exhalation valve covers. 6) Snap on the harness by putting each co ...

TABLE DES MATIÈRES I Introduction II Avertissements et mises en garde III LIMITES D’EMPLOI DU RESPIRATEUR IV Configuration et guide de sélection V Formation de l’utilisateur et instructions 1. Pourquoi utiliser une protection respiratoire 2. Remplacement des éléments protecteurs 3. Inspection avant utilisation 4. Instructions pour la mise en place, l’utilisation et le retrait du respirateur VI Entretien, nettoyage et ...

Ce produit ne doit pas être utilisé sans une bonne compréhension de tous les composants et de leur utilité. Lisez ce mode d’emploi dans son intégralité et reportez-vous-y chaque fois que vous avez un doute. Vous devez également compléter de façon satisfaisante toutes les exigences de formation fédérales et locales avant d’entrer dans une atmosphère à risque. Une attention particulière doit être ac ...

afin de garantir le remplacement des cartouches et des boîtiers filtrants avant déchirure. • Une utilisation incorrecte ou un entretien inapproprié de ce produit peut entraîner la mort ou des blessures. • Les réglementations de l’Occupational Safety and Health Administration imposent le port de lunettes étanches à l’épreuve du gaz ave ...

éléments destinés à la purification de l’air et conçus uniquement pour la protection contre les particules en suspension dans l’air NE DOIVENT PAS ÊTRE UTILISÉS pour la protection contre les vapeurs ou les gaz. Les éléments destinés à la purification de l’air et conçus uniquement pour la protection contre les vapeurs et les gaz NE DO ...