Stack-On PS-15-20-B Instructions
Text of Stack-On PS-15-20-B Instructions
Record the serial number from the tag on the
door front.
PS-15-20-B
PS-15-10-B
Hardware Included:
(4) M6 x 50 mm (2” long) Lag Screws
(4) Washers
(4) M6 x 40 mm (1-1/2” long) Plastic masonry anchors
Keep keys in a secure place away from children.
DO NOT STORE KEYS INSIDE SAFE
NOTE: Tis key has also been provided in case the
bateries run low. If you lose your key, you may
purchase a replacement key by referencing the serial
numb
When you frst receive your safe there are no
recorded fngerprints. For security you must
record a fngerprint. Failure to do so will
compromise the safety and security of the safe.
You can record up to 20 diferent fngerprints
for opening the safe.
To record a fngerprint, frst press the Reset Buton on
the inside of the safe. Te scanner will turn blue with
two beeps (if the sound is turned on) and the blue
light fashes twice, you will
To lock the safe, close the door and turn the knob to
the lef to the 12:00 position.
LOCKING THE SAFE
NOTE ON LOCKING THE SAFE: Because the
locking mechanism is deactivated for
approximately 3 to 6 seconds afer the fngerprint
is entered, wait a minimum of 6 seconds from the
time the combination is entered to lock the safe.
Also, when locking the safe, always make sure the
knob is turned completely to the lef to the 12:00
position. If the knob is not turn
SELECTING A LOCATION
SECURING THE SAFE
Figure 1
PS-15-10-B
PS-15-10-B
PS-15-20-B
PS-15-20-B
Figure 2
THE SAFE SHOULD ALWAYS BE KEPT
OUT OF THE REACH OF CHILDREN.
NOTE ON LOCKING THE SAFE: Te safe
needs to be in an upright position, as shown in
fgure 1, for the locking mechanism to function
properly. Failure to mount the safe in the correct
upright position will compromise the safety and
security of the safe.
Secure the safe to a wall stud, and to a perman
Do not use glass cleaners or sprays on this safe.
Clean with a damp cloth.
MAINTENANCE
If the door of the safe starts to rub on the door
frame, open the door per the instructions above.
By the door hinges you will fnd a threaded stem.
Use an Allen Wrench to tighten the threaded stem.
Tis will realign the door.
Tools Required:
Phillips screwdriver
5mm Allen wrench
TURNING THE SOUND OFF/ON
To turn the sound of, press the scanner with a
recorded fngerprint fo