Stack-On PDS-1800-E Instructions Manual

Text of Stack-On PDS-1800-E Instructions Manual

40791-1802 1 12

Tools Required: Drill Thin Bladed Flat Head Screwdriver Phillips Screwdriver 10 mm Wrench 1/4” (7 mm) Drill Bit *3/8” (9.5 mm) Masonry Brill Bit for drilling into masonry *3/16” (5 mm) Drill Bit for drilling into wood and wall studs * For model PDS-1805-E only PDS-1800-E Hardware Included: (2) M6 x 15 mm (5/8” long) Screws (2) M6 Nylock Nuts PDS-1805-E Hardware Included: (4) M6 x 50 mm (2” long) Lag Screws (4) M6 x 40 mm (1-1/2”

40791-1802 2 12

ENTERING YOUR SECURITY CODE To enter your own security code you will need to follow the steps listed below: 1. After installing the batteries, locate the reset button on the back of the door. 2. Press the reset button with a pen and then release it, you will hear a beep. DO NOT SHUT THE DOOR UNTIL YOU HAVE CONFIRMED THAT YOUR NEW SECURITY CODE HAS BEEN ENTERED CORRECTLY. 3. With the door open, enter your own personal security code, whi

40791-1802 3 12

SECURING THE SAFE DRAWER MOUNTING Select an appropriate sized drawer for your safe. Place the safe in the drawer and try opening and closing the safe and drawer. Do not attempt to close the drawer with the safe open. Place the safe in the desired drawer and mark the mounting holes with a pencil. Remove the safe and drill the pilot holes for the screws. Replace the safe in the drawer and insert the screws through the mounting holes and dra

40791-1802 4 12

If the door of the safe starts to rub on the door frame, open the door per the instructions above. By the door hinges you will find a threaded stem. Use an Allen Wrench to tighten the threaded stem. This will realign the door. MAINTENANCE Tools Required: Phillips screwdriver 5mm Allen wrench WALL MOUNTING (FOR MODEL PDS-1805-E ONLY) TIP: A securely fastened cleat (A) mounted level and at the appropriate height will aid in mounting the s

40791-1802 5 12

® Key / Combination / RFID Device Request This is not a Registration Form Verification of ownership is required in order to receive a replacement Key / Combination / RFID devices for your security product. In order to receive a replacement Key or Combination or RFID devices for your security product: 1. Please visit the following link: https//www.stack-on.com/customer-service/ 2. Locate and click on the "Replace your lost keys/combination"

40791-1802 6 12

LIMITED THREE YEAR WARRANTY STEEL SAFES Stack-On Products Co. (“Stack-On”) Steel Safes are warranted to be free from defects in material and workmanship for a period of three (3) years from the date of original purchase by a consumer. This warranty extends to the initial consumer only. If you believe there is a defect in material or workmanship in your Steel Safe during the three-year warranty period, please contact our customer service

40791-1802 7 12

® IMPORTANTE Registre el número de serie ubicado en la parte de atrás de la caja fuerte o de la etiqueta ubicada adentro de la tapa de la cerradura en la parte de enfrente de la unidad. Registre los números de combinación. # Serie: # Combinación Electrónica NOTA: Usted puede almacenar su Numero de Llave y su Nymero de Combinacion en el web site SEGURO de - stack-on.com bajo la opcion que dice Servicio Al almacenar su N

40791-1802 8 12

Para cerrar la caja fuerte, cerrar la puerta y girar la perilla hacia la izquierda a la posición de las 12:00. NOTA DE BLOQUEO DEL SEGURO: Debido a que el mecanismo de bloqueo está desactivado durante aproximadamente 3 a 6 segundos después de la combinación se ingresa, espere un mínimo de 6 segundos a partir del momento en que se entró en la combinación para cerrar la caja fuerte. Además, al cerrar la caja fuerte, siempre asegúrese

40791-1802 9 12

NOTA: No mezcle pilas viejas y nuevas. No mezcle pilas alcalinas, pilas estándar o recargables. Este seguro utiliza 4 - pilas AA. En condiciones de uso normal, las pilas duran aproximadamente 1 año. NOTA: Si las baterías están bajas, la luz amarilla parpadea cuando se empieza a introducir el código. Para reemplazar las pilas, abra el compartimiento de las pilas, ubicado en la parte de atrás de la puerta, oprimiendo la pestaña en el s

Mantenga las llaves y el número de combinación en

un lugar seguro, lejos de los niños. Mantenga un registro de su número de serie y la combinación en un lugar seguro separado de su caja fuerte. Para pedir una llave de recambio, siga las instrucciones en el formulario adjunto. 40791-1802 1012 Si la puerta de la caja fuerte comienza a raspar el marco de la puerta, abra la puerta según las instrucciones. Cerca de las bisagras encontrará un t

Stack-On Safes Owners Instructions: