DYNATEK DFCH-5 Operation & User’s Manual

Text of DYNATEK DFCH-5 Operation & User’s Manual

Dynatek • 164 S. Valencia St. Glendora CA 91741

www.dynaonline.com 800.928.3962 User Manual Parts List FI Controller Installation Guide Wire tap Wire ties Velcro® Strip Alcohol Swab 2002-2005 Harley Davidson V-Rod Models Part Number DFCH-5 2801190 REV. 8-11-05 Congratulations on your purchase of this Dynatek product. Please take a moment to read these instructions completely before installing the FI controller. The installation will only take a few mi

Tools required: 5mm Hex wrench, 10mm

socket, pliers Lift the seat. Remove the airbox cover. Unplug the sensor at the front of the airbox. Undo the 8 clamps on the airbox, and remove the lid. There are 3 clamps on each side, 1 at the front and 1 at the rear. Remove the air filter. Using the 5mm Hex wrench, remove the 3 bolts at the base of both of the air horns inside the airbox. Use the pliers to loosen the clamp on the breather hose that goes from the ai

From the right side of the bike, unplug the

fuel injector connectors. Pull the harness down so it is out of the way. Note that there is a label on them for "FRONT" and "REAR" cylinder. Take the FIC harness, and feed it under the throttle bodies, then through to the right side of the bike. On the FIC harness, find the 2 connectors with the orange wire. Plug these into the front injector harness, and then into the front injector. The yellow wire with the gre

Unplug the Throttle Position Sensor(TPS)

connector from the throttle body on the front cylinder. If there is a black wire loom over the 3 wires to the TPS, remove this loom. Locate the red wire tap supplied in the kit. Crimp the wire tap onto the grey wire with the purple stripe on the TPS connector. It is at position "C" on the TPS connector. Plug the TPS connector back into the throttle body. Plug the grey wire from the FIC harness into the wire tap on t

DYNATEK DFCH-5 For Tech Support: 800.928.3962

Controls The FI Controller is preprogrammed with 4 base fuel curves. The curves are selected using the switch labeled BASE. These curves adjust fuel delivery based on throttle position and RPM, providing the right amount of fuel under all conditions. The 4 fuel curves correspond to varying levels of performance modifications. The levels of modification are broken down into the following groups. Base Curve 1 - Slipon exhaust o

DYNATEK Other Owners Instructions: