Simplex 4100-6062 Installation And Programming Instructions

Specifications and other information shown were current as of publication and are subject to change without notice. Tyco Safety Products, Simplex and the Simplex logo AUTOCALL, TFXnet, and CONSYS are trademarksare trademarks of Tyco International Ltd. and its affiliates and are used under license. 4100-6 ...

Related Documentation Replacing 4100U/4100ES Single Page Operating Instructions Adding the TFXi to the FACP changes the way in which opera- tors interact with the FACP panel. Replace the single page oper- ating instruction shipped with the FACP with the appropriate TFX Interface instruction listed be ...

Figure 3 Internal Baud/Address Dipswitch Installing TFXi Card in an FACP Bay Installation guidelines differ slightly, depending on whether the TFXi is being installed in a CPU or expansion bay. Parts List CPU Bay Installation Guidelines • Up to two 2 x 11.5” motherboards, such as the one used ...

left to right. Slide the motherboard to the left until the pins are completely inserted in the connector. For a CPU bay, install motherboards from right to left. Slide motherboard to the right until pins are completely inserted in connector. Figure 6 Connecting 2” x 11.5” Motherboards Securin ...

Wiring TFXi to TLT-530 Use harness 734-165 to connect the TFXi to the TLT-530 net- work interface module. Connect the end of the harness contain- ing the DB-25 connector to Port A on the TFXi daughter card. Connect the end of the harness with the RJ-11 connector to PL2 on the TLT-530. The length of t ...

Note: Set Switch SW1 on the TLT-530 for third party operation as shown above. Do not use the third-party switch settings listed in Table 5 of 19700344-5a. These are switch SW2 designations for the TLI-530 and TLT-530 modules. Note: OFF = Value (1=Off, 0=ON) Table 5: LK Header Configuration Header Lin ...

Figure 11 TLT-530 and RPS-424 Wiring ��� �� � �� � ��� �� � � �� � �� � ��� �� � � ��� �� ��� ��� ��� � � � � � �� � �� � �� � �� � ������� �������� ...

IDC Monitoring Operation The IDC is used to monitor normally open contacts of the PSM (976123). The contact will open if the RPS-424 indicates an AC loss, ground fault, battery low or battery missing. The correct EOLR is placed across the Com and NC contacts (relay is nor- mally energized). The IDC m ...

Figure 13 Subnet Tab Zones Tab Settings The Zones Tab allows you to specify the zone links and sectors corresponding to the zones used by the TFXnet and FACP. Zones, zone links, and sectors are logical groupings of TFXnet points. Understanding the role of zone links is especially important when c ...

c. For a non-trouble event, choose Active; otherwise select Trouble. d. Click on the Group drop down list box and select the group for the zone (from your CONSYS job). 3. On the FACP, program the action that should occur when the pseudo point activates (turns on). Options include: - Start Custom Con ...