Envision EN7100e Operation & User’s Manual

Text of Envision EN7100e Operation & User’s Manual

EN-7100e TBC 6332
EN-7100e 17 inch TFT LCD Monitor User’s Manual by Envision Peripherals, Inc. www.ENVISIONmonitor.com Before operating your monitor, please read this manual thoroughly.
For Your Safety
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate ra
Do not use the monitor near water, e.g. near a
bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement. • Do not place the monitor on an unstable cart, stand, or table. If the monitor falls, it can injure a person and cause serious damage to the appliance. Use only a cart or stand recommen
For Your Safety
Special Notes on LCD Monitors The following symptoms are normal with an LCD monitor and do not indicate a problem: • Due to the nature of the fluorescent light, the screen may flicker during initial use. Turn off the Power Switch and then turn it on again to make sure the flicker disappears. • You may find sligh
Before You Operate the Monitor
Installing & Removing the Base General Features: • 17" (43.2cm) TFT Color LCD Monitor • Crisp, Clear Display for Windows • 1280 X 1024 pixels @75Hz Maximum & Recommended Resolution • EPA ENERGY STAR® • Ergonomic Design • Space Saving, Compact Case Design Package Contents The box that your
Before You Operate the Monitor
Connecting the Wires Using the Power Cord Supplied 1. Connect the built-in video cable into the 15-pin connector on the back of your computer and tighten the two screws. 2. Connect the power cord into the power adaptor. 3. Plug the other end of the power cord into a grounded AC outlet or UL-approved p
Before You Operate the Monitor
Connecting the Wires Using An Optional Power Cord (Not Supplied) The power cord supplied with your monitor can only be connected to a grounded electrical wall socket or power strip. If you wish to connect your monitor to a power supply using the power input socket on the back of your computer, you mus
Before You Operate the Monitor
Preparing to Install An Optional Wall Mounting Arm (Not supplied) This monitor can be attached to a wall mounting arm you purchase separately. Disconnect power before this procedure. Follow these steps: 1. Pull the screw covers off the back of the monitor. 2. Support the base and remove the screws. 3.
Before You Operate the Monitor
Install An Optional Wall Mounting Arm (Not supplied) Follow these steps to finish installing the wall mounting arm: 1. Place the wall mounting arm onto the back of the monitor. Line up the holes of the arm with the holes in the back of the monitor. 2. Insert the 4 screws into the holes and tighten. 3.
Before You Operate the Monitor
Adjusting the Viewing Angle For optimal viewing, adjust the monitor's angle to your own preference. • Hold the stand firmly when you change the monitor's angle. • You can adjust the monitor's angle from -5° to 30°. • Do not touch the LCD screen when you change the angle. It may cause damage o

Envision Monitor Owners Instructions: