Troy-Bilt 4510 Operator's Manual

Text of the manual

TROY-BILT LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019

Printed In USA Operator’s Manual Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty WARNING READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE. FAILURE TO COMPLY WITH THESE INSTRUCTI

To The Owner

1 2 Record Product Information Before setting up and operating your new equipment, please locate the model plate on the equipment and record the information in the provided area to the right. You can locate the model plate by standing at the operator’s position and looking at the lower, rear section of the frame. This information will be neces

Important Safe Operation Practices

2 3 Training Read, understand, and follow all instructions on the 1. machine and in the manual(s) before attempting to assemble and operate. Keep this manual in a safe place for future and regular reference and for ordering replacement parts. Be familiar with all controls and their proper operation. 2. Know how to stop the

Section 2 — Important Safe Operation Practices

Safe Handling of Gasoline To avoid personal injury or property damage use extreme care in handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Serious personal injury can occur when gasoline is spilled on yourself or your clothes which can ignite. Wash your skin and change clothes

Section 2 — Important Safe Operation Practices

Maintenance & Storage Never tamper with safety devices. Check their proper 1. operation regularly. Refer to the maintenance and adjustment sections of this manual. Before cleaning, repairing, or inspecting machine 2. disengage all control levers and stop the engine. Wait until the auger/impeller come to a co

Section 2 — Important Safe Operation Practices

Safety Symbols This page depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Symbol Description READ THE OPERATOR’S MANUAL(S) Read, understand, and follow all instructions in the manua

Secure the upper handle and lower handle with the two

4. wing nuts and carriage bolts removed earlier. Tighten the two wing nuts already installed in the upper holes to firmly secure the upper handle and support tubes. See Figure 3-2. Align the upper and lower shift rods, then slide the shift rod 5. connector down over the end of the lower shift rod. Tap the

Place chute assembly onto chute base as shown in Figure 3-5.

Make sure that the chute notches engage with the spiral end of chute directional control, and the two flange keepers are beneath the flange on the chute base. Secure flange keeper removed earlier with lock nuts and screws. Tighten down nuts securing the other two flange keepers. See Figure 3-6. Che

Auger and Drive Control Cables

Warning! Prior to operating your snow thrower, carefully read and follow all instructions below. Perform all adjustments to verify your snow thrower is operating safely and properly. Testing Auger Drive Control When the auger control is released and in the disengaged “up” position, the cable should have very little slack.

More Troy-Bilt Snow Blower Owners Instructions: