Troy-Bilt 521 Operator's Manual

Text of the manual

Models 521 & 721

PRINTED IN U.S.A. Operator’s Manual FORM NO. 769-00309.fm (8/2002) IMPORTANT: Read safety rules and instructions carefully before operating equipment. TROY-BILT LLC. P.O. BOX 361131 CLEVELAND, OHIO 44136-0019 Warning: This unit is equipped with an internal combustion engine and should not be used on or near any un

TABLE OF CONTENTS

Content Page Important Safe Operation Practices .................................................................................. 3 Assembling Your Snow Thrower ....................................................................................... 5 Know Your Snow Thrower..................................................................

SECTION 1: IMPORTANT SAFE OPERATION PRACTICES

DANGER: This machine was built to be operated according to the rules for safe operation in this manual. As with any type of power equipment, carelessness or error on the part of the operator can result in serious injury. This machine is capable of amputating hands and feet and throwing objects. Failure to obse

Never operate with a missing or damaged discharge

chute. Keep all safety devices in place and working. 5. Never run an engine indoors or in a poorly ventilated area. Engine exhaust contains carbon monoxide, an odorless and deadly gas. 6. Do not operate machine while under the influence of alcohol or drugs. 7. Muffler and engine become hot and can cause

SECTION 2: ASSEMBLING YOUR SNOW THROWER

Unpacking From Carton • Cut along corners of the carton and lay it down flat. Remove packing material. • Remove any loose parts included with unit (i.e., operator’s manual, etc.). • Roll unit out of carton. Check carton thoroughly for any remaining loose part. Items Required For Assembly 1. Pair of pliers 2.

handle. Hold the “Z” fitting with the pliers, not the

cable, to avoid damaging the cable. NOTE: The upper hole in the control handle provides for adjustment in belt tension. Refer to page 9 of this manual for instructions. Assembling Discharge Chute • Turn the chute crank until the chute faces straight to the front. See Figure 4 . • Remove the hand

The angle of the discharge chute controls the distance

that the snow is thrown. Tilt the discharge chute up for greater distance; tilt down for less distance. Loosen the hand knob on the side of the discharge chute to adjust. Tilt the chute to the desired position, and tighten the knob. Choke Lever The location of the choke lever is indicat

If you have a grounded three-prong receptacle,

proceed as follows. • Rotate choke lever to FULL position. • Connect power cord to switch box on dash panel. Plug the other end of power cord into a three-prong 120-volt, grounded, AC receptacle. • Push starter button to crank engine. As you crank the engine, move choke lever to FULL choke position.

SECTION 5: MAKING ADJUSTMENTS

Shave Plate • To check the adjustment of the shave plate, place the unit on a level surface. See Figure 8. The wheels, shave plate and augers should all contact level surface. Note that if the shave plate is adjusted too high, snow may blow under the housing. If the shave plate wears out excessively, or the unit does not s

SECTION 6: MAINTAINING YOUR SNOW THROWER

Replacing Belt • Remove the belt cover by removing five hex screws. See Figure 12. Figure 12 • Pull up on the idler pulley and slip the belt off the engine pulley. See Figure 13. Figure 13 • Push down on the idler pulley and slip the belt off the auger pulley. See Figure 13. • Reassemble new belt. Reinstal

More Troy-Bilt Snow Blower Owners Instructions: