Troy-Bilt S6R72 Operator's Manual

Text of the manual

Snow Thrower Models

$6R72 (7524)nStorm E6S73 (8526)mStorm IMPORTANT: READ SAFETY RULES AND INSTRUCTIONS CAREFULLY WARNING: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest- covered, brush-covered or grass-covered land unless the engine's exhaust system is equipped

Important Safe Operation Practices ........................................................................

3 Assembling Your Snow Thrower ............................................................................. 5 Know Your Snow Thrower ....................................................................................... 6

This symbol points out important safety instructions, which if not followed, could endanger the personal

safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting to operate this machine. Failure to comply with these instructions may result in personal injury. Wh

4. Neveroperatewithamissingordamaged discharge chute.Keepallsafetydevicesinpieceandworking. 5. Neverrunanengineindoorsorinapoorlyventilated area.Engineexhaustcontainscarbonmonoxide, an odorlessanddeadlygas. 6. Donotoperatemachine whileundertheinfluence of alcoholordrugs. 7. Mufflerandenginebecomehotandcancauseaburn.Do nottouch. 8. Exercise extremecautionwhen

to right or left side of the snow

thrower are determined from behind the unit in the operating position. The "operator's position" is defined as standing directly behind the snow thrower, facing the handle panel LooseParts • The augers are secured to the auger shaft with two shear bolts and hex lock

Remove the hairpin clip from the upper chute crank

and slide the upper chute crank through the bracket and into the lower chute crank. See Figure 4. • Align the two holes on both chute cranks and insert the hairpin clip removed earlier, through these holes. See Figure 4. Upper Chute Crank Figure 4 RoutingChuteTiltCables

Traction Control /

Auger Control Lock Headlight Fuel Tank Discharge Chute Clean-out Tool _hute Directional Control Electric Starter 3utton Primer.x Switch Box Choke._. Auger Safety Ignition Km Throttle Control Starter Handle Shift Lever The shift lever is located in the center of the handle panel and is used to determine ground speed and direction of travel.

Headlights(Model 8526 Only)

When properly connected, headlight illuminate whenever the engine is running. SECTION4: OPERATINGYOURSNOWTHROWER BeforeStarting i_ WARNING: Read, understand, and follow all instructions and warnings on the machine and in this manual before operating. GasAndOilFill-up Service the engine with gasoline and oil as instructed in the se

Always cover vent hole in primer button when

pushing. Additional priming may be necessary for first start if temperature is below 15°F. • Grasp starter handle and pull rope out slowly, until it pulls slightly harder. Let rope rewind slowly. • Pull starter handle rapidly. Do not allow handle to snap back. Allow it to rewind slowly while keeping a f

Squeeze the traction control against the right

_1_ handle and the snow thrower will move. Release it and the drive motion wilt stop. IMPORTANT: NEVER move the shift lever without first releasing the traction control. Doing so will cause 5. premature wear to the drive system's friction wheel. Wheel SteeringControls 6. The left and right wheel steering con

More Troy-Bilt Snow Blower Owners Instructions: