Troy-Bilt Polar Blast 4510 Snow Thrower Operator's Manual

Text of the manual

TROY-BILT LLC, P.O. BOX 361131 CLEVELAND, OHIO 44136-0019

Printed In USA Operator’s Manual Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty WARNING READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE. FAILURE TO COMPLY WITH THESE INSTRUCTI

To The Owner

1 2 Record Product Information Before setting up and operating your new equipment, please locate the model plate on the equipment and record the information in the provided area to the right. You can locate the model plate by standing at the operator’s position and looking at the lower, rear section of the frame. This information will be neces

Important Safe Operation Practices

2 3 Training 1. Read, understand, and follow all instructions on the machine and in the manual(s) before attempting to assemble and operate. Keep this manual in a safe place for future and regular reference and for ordering replacement parts. 2. Be familiar with all controls and their proper operation. Know how to stop the

Section 2 — Important Safe Operation Practices

Safe Handling of Gasoline To avoid personal injury or property damage use extreme care in handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Serious personal injury can occur when gasoline is spilled on yourself or your clothes which can ignite. Wash your skin and change clothes

Section 2 — Important Safe Operation Practices

Clearing a Clogged Discharge Chute Hand contact with the rotating impeller inside the discharge chute is the most common cause of injury associated with snow throwers. Never use your hand to clean out the discharge chute. To clear the chute: 1. SHUT THE ENGINE OFF! 2. Wait 10 seconds to be sure the impeller

Section 2 — Important Safe Operation Practices

Safety Symbols This page depicts and describes safety symbols that may appear on this product. Read, understand, and follow all instructions on the machine before attempting to assemble and operate. Symbol Description READ THE OPERATOR’S MANUAL(S) Read, understand, and follow all instructions in the manua

Looking beneath the handle panel, check that all of the

cables (steering, auger, and drive) are properly routed and not pinched or kinked. Make certain the springs at the lower end of the auger and drive cables are securely hooked into their respective actuator bracket. See Figure 3-11. 5. Secure the upper handle, support tubes and lower handl

Secure flange keeper removed earlier with lock nuts and

screws. Tighten down nuts securing the other two flange keepers. See Figure 3-5. 4. Check that the chute cables are properly routed through the cable guide attached to the lower handle assembly. See Figure 3-6. Set-Up Shear Pins A pair of replacement auger shear pins and bow tie cotter pin

More Troy-Bilt Snow Blower Owners Instructions: