Sharp R-2380 Service Manual

Text of Sharp R-2380 Service Manual

In interests of user-safety

the oven should be restored to its original condition and only manufacturer original spare parts must be used. TABLE OF CONTENTS Page CAUTION, MICROWAVE RADIATION .......................................................................................................... 1 GENERAL IMPORTANT INFORMATION .......................................................

Sharp R-2380 has been prepared to provide Sharp Corp. Service

Personnel with Operation and Service Information for the SHARP MICROWAVE OVEN R-2380. It is recommended that service personnel carefully study the entire text of this manual so they will be qualified to render satisfactory customer service. Check interlock switches and door seal carefully. Special at- tention should be given to

Sharp R-2380 Cooking Cavity Dimensions

Control Complement Set Weight DESCRIPTION 240 Volts 50 Hertz Single phase, 3 wire earthed Microwave cooking 2.4 kW Approx. 10.0 A 1300 watts nominal of RF microwave energy (2 litter water load) Operating frequency of 2450MHz Width 510 mm Height 335 mm including foot Depth 415 mm Width 330 mm Height 210 mm Depth 310 mm Tou

THE WIRES IN THIS MAINS

LEAD ARE COLOURED IN ACCORDANCE WITH THE FOLLOWING CODE: GREEN-AND-YELLOW : EARTH BLUE : NEUTRAL BROWN : LIVE APPEARANCE VIEW L*+ YLECTATME enter 11”w Fa “Ma lOox sELECTwowER e&ynbn la wxnlws I j 6 1 I I 7 1 I ! 9 I I / iol @j-j SELECTATIME 11 STOPKLEAR pj$ @$-fGq,,,b 8--Ts;f7 CHECK pLGq-@ 7 1. Door handle. 2. Access cover for oven lamp replacement. 3.

Closing the door activates all door interlock switches

(Upper latch switch, lower latch switch and stop switch) IMPORTANT 5. When the oven door is closed, the monitor switch contacts COM-NC must be open. When the microwave oven is pluged in a wall outlet (240 volts, 50Hz), the line voltage is supplied to the point A5+ A7 in the control panel. Figure O-1 on page 48 The display shows 1-I. NOTE: When the door is opened or a

MGl + MG2 are equipped

in order to get higher microwave power output. The primary windings of the power transformers Tl + T2 are connected so that each magnetron can be oscillated alternatively according to the frequency of the power supply. Refer to the Figure 1 and 2. \ T2: POWER TRANSFORMER r-----7 Tl: POWER TRANSFORMER r---+J=f--- 0: H. V. RECTIFIER C2: tZ~;P&ITOR AC2:OO” ASYMMETRIC RECTIFIER U 0:

When the microwave

oven is preset for variable cooking power, the line voltage is supplied to the power transformers Tl + T2 intermittently within a 32 second time base through the contacts of the relays RY3+ RY4. The following levels of microwaves power are given. Number key Number key 9 Number key 8 Number key 7 Number key 6 Number key 5 Number key 4 Number key 3 Number key 2 Number key 1 Number key 0 30 set ON 26 set ON 24 set

SW1 + SW2 + SW4

1. When the oven door is COM-NO must be closed. 2. When the oven door is COM-NO must be opened. MONITOR SWITCH SW3 closed, the contacts opened, the contacts The monitor switch is activated (the contacts opened) by the upper latch head and switch lever A while the door is closed. The switch is intended to render the oven inoperative by means of blo

motor drives a blade which

draws external cool air. This cool air is directed through the air vanes surrounding the magnetrons and cools the magnetrons. This air is channeled through the oven cavity to remove steam and vapors given off from the heating foods. It is then exhausted through the exhausing air vents at the oven cavity. MG THERMAL CUT-OUTS 145°C TCI, TC2 These thermal cut-outs protect the magnetrons against ov

Touch START pad for 2 seconds.

1 w After 2 sec. an entry signal il sounds. Touch CHECK pad for 2 seconds. pi-j llyvllr*i. (For 2 sec.) 2 After 2 seconds. m (Total times used) Touch NUMBER pad II. El p-y--q (Times of using memory 1) Touch SELECTATIME pad. 3 pizGq /I (Times of manual cooking) Touch EXPRESS DEFROST pad. l--EEq jl (Times of EXPRESS DEF- ROST cooking) Although the owner can clear all memories (i

Resetting the counter memory

When the counter memory is displayed on the readout (see page 9 Counter Check), the count can be reset to zero by touching the SELECTAPOWER pad for 2 seconds To reset memory 1 to zero. itep Procedure Order Touch START pad for 2 seconds. rxz---j 1 (For 2 sec.) After 2 sec. an entry signal sounds. Touch CHECK pad for 2 seconds. I CHECK (For 2 sec.) Touch NUMBER pad II. I 1 Touch SELECTAPOWER pad for 2 seconds. pGq (For 2 sec.) 4

Sharp R-2380 One or two stage cooking can be programmed

into any of the 10 programme positions. To programme the time and power level into a memory l Suppose you wish to enter 4 minutes at 60% for a single quantity in the memory 1 itep Procedure Touch START pad for 2 seconds. 1 2 Touch NUMBER pad II. 3 Touch SELECTATIME pad. 4 gh NUMBER pads 141 , 101 and 5 Touch SELECTAPOWER pad. Order Display Ez I’ After 2 sec. an entry signal sounds. I 6 Touch NUMBER pad 161. I 6

To change the time constant for double quantity

The time constant for double quantity is preset 1.8 times the single quantity cooking time, but you can alter this constant to suit your needs. l Suppose you wish to alter the time constant to 1.67 in memory 1. - ;tep Order Display Touch START pad for 2 seconds. 1 START 1 (For 2 sec.) After 2 sec., an entry signal sounds. 1 2 - 3 4 5 6 Touch DOUBLE QUANTITY pad for 2 seconds. 1 NUMBER I (For 2 sec.) After 2 s

To set te constants of Express Defrost to factory setting:

1st sequence: 20% of total time at 40% power. 2nd sequence: 30% of total time at 30% power. 3rd sequence: 50% of total time at 20% power. itep Procedure Order Display Touch START pad for 2 seconds. 1 !izz i After 2 sec. an entry signal sounds. 2 Touch SET pad. m 1”“___1 3 Touch START pad. /I r”-l 4 Touch EXPRESS DEFROST pad. l---EEq v”il 5 Touch SELECTATIME pad. LIEff

--_. . _---

__. ..- Step Procedure Order Display Touch NUMBER pad 141. 10 El -1 Touch SELECTATIME pad. 11 LEEEEl p-x&--j 12 Touch NUMBER pads a, 131. mEr /r0-‘i3 Touch SELECTATIME pad. 13 pzEq v\ 14 Touch NUMBER pad 131. m VI Touch SELECTAPOWER pad. 15 ISELECTAPOWER/ -1 16 Touch NUMBER pad 131. m p---ygq Touch SELECTATIME pad. 17 y=l /I Touch NUMBER pad a. El 18 il Touch SELECTAPOWER pad. 19 ~ p-----q 20 Touch NUMBER pad /21. m p----q 21

Sharp R-2380 capable of producing

very high voltage and current, contact with any part of the high voltage circuit will result in electrocution. REMEMBER TO CHECK JlJ 1) Disconnect the supply. 2) Door opened, and wedged open. 3) Discharge high voltage capacitor, after remov- ing the outer case cabinet and rear cabinet, WARNING AGAINST THE CHARGE OF THE HIGH-VOLTAGE CAPACITOR The high-voltage capac

direct cause and part. “A”

means indirect cause and part. m - - m - H.V. RECTIFIER ASSEMBLY WITH HVC HARNESS ASSEMBLY - 5 5 g F u 2 i s: - - - - - - - I LL d I- I :: Z Lt. tu - z 5 !I 5 8 ii4 - - ( - - - ~ c I 1 L - 2 s 5 ii a - - - - - - - - w - 5 co 6 2 5 2 A oz 2 5 - - - C - r a w - 3 e 0 E, E P u “, s ?i z - - - - - a f 4 5 i - - - r- - N 9 z F F M LT 5 rr’ PROBLEM i does not appear in display but power supply cord is plugg

Sharp Microwave Oven Owners Instructions: