GE DPSB620EC Owner's Manual

Operating Instructions Control Panels . . . . . . . . . . . . . . . . 6, 7 Controls Features . . . . . . . . . . . . . .12 Cycle Options . . . . . . . . . . . . . . . . . .13 Cycle Status . . . . . . . . . . . . . . . . . . .14 Dryer Features . . . . . . . . . . . . . . . . .15 Drying Cycles . . . . . . . . . . . . . . . . . .10 Dryness Levels . . . . . . . . . . . . . . . . .11 EASY TOUCH Selections . . . . . . . . . .7, 9 Heat Settings . . . . . . . . . . . . . . . . . .11 Loading and Using the Dryer . . . . . . . . . . . . . . . . . . . .17, 18 Quick Start Guides . . . . . . . . . . . . .6, 8 Rever ...

READ ALL INSTRUCTIONS BEFORE USING. California Safe Drinking Water and Toxic Enforcement Act This act requires the governor of California to publish a list of substances known to the state to cause cancer, birth defects or other reproductive harm and requires businesses to warn customers of potential exposure to such substances. Gas appliances can cause minor exposure to four of these substances, namely benzene, carbon monoxide, formaldehyde and soot, caused primarily by the incomplete combustion of natural gas or LP fuels. Properly adjusted ...

governing codes and ordinances. Follow details in Installation Instructions. IInstall or store where it will not be exposed to temperatures below freezing or exposed to the weather. IConnect to a properly rated, protected and sized power supply circuit to avoid electrical overload. IRemove the colored protective film from the control panel. IRemove all sharp packing items and dispose of all shipping materials properly. Exhaust/Ducting: Gas dryers MUST be exhausted to the outside. Use only rigid metal 4″ diameter ductwork inside the dryer cabinet. Use only rigid metal or flexible metal 4″ diameter ductwork ...

READ ALL INSTRUCTIONS BEFORE USING. WARNING! YOUR LAUNDRY AREA I Keep the area underneath and around your appliances free of combustible materials (lint, paper, rags, etc.), gasoline, chemicals, and other flammable vapors and liquids. I Keep the floor around your appliances clean and dry to reduce the possibility of slipping. I Close supervision is necessary if this appliance is used by or near children. Do not allow children to play on, with or inside this or any other appliance. I Keep all laundry aids (such as detergents, bleaches, etc.) out of the reach of children, preferably in a locked cabinet. Observe all warning ...

I Grasp the plug firmly when disconnecting this appliance to avoid damage to the cord while pulling. Place the cord away from traffic areas so it will not be stepped on, tripped over or subjected to damage. I Do not attempt to repair or replace any part of this appliance or attempt any servicing unless specifically recommended in this Owner’s Manual or in published user-repair instructions that you understand and have the skills to carry out. I Before discarding a dryer, or removing it from service, remove the dryer door to prevent children from hiding inside. I Do not tamper with controls. READ AND FOLLOW THIS SAFETY INFORM ...

Quick Start Guide for Model DPSB620. Clean the lint filter. IMPORTANT: Clean the lint filter each time you use the dryer. Add clothes. Do not overload. This wastes energy and causes wrinkling. Select the dry cycle and other options. For TIMED DRY, use the SET TIME arrow pads to set the drying time. NOTE: Any time you make a selection that is incompatible with the chosen dry cycle, the dryer will beep twice. Change any of the automatic settings, if desired, by pressing the pad beneat ...

ge.com Your new dryer offers the convenience of starting your dryer loads with our EASY TOUCH cycles. Make one simple selection, and your LOAD SIZE, DRYNESS LEVEL and TEMP SETTING are automatically set. Then all you have to do is press START. COTTONS For cottons and most linens. MIXED LOADS For loads consisting of cottons and poly-blends. PERM PRESS For wrinkle-free, permanent press and delicate items, and knits. KNITS For knits with fabric care labels that say “Machine Dry.” WOOLENS DELICATES For lingerie and special-care fab ...

Quick Start Guide for Model DPSB650. Clean the lint filter. IMPORTANT: Clean the lint filter each time you use the dryer. Add clothes. Do not overload. This wastes energy and causes wrinkling. Select one of the three drying methods: I Press SENSOR CYCLES to dry according to load type I Press GARMENT CYCLES to dry according to clothing type I Press TIMED DRY to specify dry time Select the dry cycle by pressing the arrow pads ( ) at the sides of the display. You can scroll up and down ...

ge.com SENSOR CYCLES Your new dryer offers the convenience of starting your dryer loads with our EASY TOUCH cycles. Make one simple selection, and your LOAD SIZE, DRYNESS LEVEL and TEMP SETTING are automatically set. Then all you have to do is press START. COTTONS For cottons and most linens. PERM PRESS For wrinkle-free, permanent press and delicate items, and knits. MIXED LOAD For loads consisting of cottons and poly-blends. KNITS For knits with fabric care labels that say “Machine Dry.” SPEED DRY For small loads that are neede ...

used if the previous cycle left some items damp, such as collars or waistbands. DEWRINKLE Use this feature to remove wrinkles from items that are dry or slightly damp. This cycle is not recommended for delicate fabrics. AIR DRY Use this feature to tumble items without heat. CUSTOM Cycles (on some models) Set up your favorite combination of settings and save them here for one-touch recall. These custom settings can be set while a cycle is in progress. To store a custom com ...

DRY Use for a normal dryness level suitable for most loads. This is the preferred cycle for energy saving. LESS DRY Use for lighter fabrics. DAMP For leaving items partially damp. About dryness levels. ge.com HIGH For regular to heavy cottons. MEDIUM For synthetics, blends and items labeled permanent press. LOW For delicates, synthetics and items labeled Tumble Dry Low. EXTRA LOW For lingerie and special-care fabrics. About heat settings. ...

I Press twice to select the last cycle used and start the dryer. I If the dryer is running, press once to interrupt the cycle; press again to continue the cycle. Throughout this manual, features and appearance may vary from your model. About controls features. STOP If the dryer is running, press once to interrupt the cycle; press again to cancel the cycle. Time Remaining Displays the approximate time remaining until the end of the cycle. As the cycle begins, you will see the approximate total cy ...

NOTE: Not all features are available on all dryer models. ge.com (Appearance and features may vary) SIGNAL Alerts you that the cycle is complete. The beeper will continue to sound every two minutes for the next 6 minutes, until the clothes are removed. The clothes should be removed when the beeper goes off so wrinkles won’t set in. Press SIGNAL to select low, medium or high volume, or to turn the beeper off. EXTEND TUMBLE PLUS Minimizes wrinkles by adding approximately 60 minutes of no-heat tumbling after clothes are dry. The beeper will sound eve ...

clean the lint filter. On models without indicator lights, the cycle status will show in the display. About cycle status. SENSING This light comes on when an EASY TOUCH Sensor Dry Cycle is active. TIMED DRY This light comes on when AIR DRY, DEWRINKLE, DRYEL™(on some models), TIMED DRY or RACK DRY is selected. EXTENDED TUMBLE This light comes on when the dryer is in the EXTEND TUMBLE mode. CLEAN LINT FILTER This light is a reminder to clean the lint filter. ...

ge.com Drying Rack (on some models) A handy drying rack may be used for drying delicate items such as washable sweaters. Hook the rack over the lint filter so the rack extends into the dryer drum. NOTE: I The drying rack must be used with the TIMED DRY or RACK DRY (on some models) cycles. I Do not use this drying rack when there are other clothes in the dryer. Drum Lamp Before replacing the light bulb, be sure to unplug the dryer power cord or disconnect the dryer at the household distribution panel by removing the fuse or switching off the circuit ...

Tools needed: I Standard #2 I Tape-tipped Phillips screwdriver putty knife Open the door and remove the filler plugs opposite the hinges. With the door completely open, remove the bottom screw from each hinge on the dryer face. Insert these screws about halfway into the TOP holes, for each hinge, on the opposite side (where you removed the filler plugs). Apply firm pressure to get the screw started in new holes. Loosen top screw from each hinge on the dryer face halfway. With one hand holding the top of the door and the other hand holding the bottom, ...

Below are fabric care label “symbols” that affect the clothing you will be laundering. Always follow the fabric manufacturer’s care label when laundering. Loading and using the dryer. ge.com Consumer Support Troubleshooting Tips Operating Instructions Safety Instructions Sorting and Loading Hints As a general rule, if clothes are sorted properly for the washer, they are sorted properly for the dryer. Try also to sort items according to size. For example, do not dry a sheet with socks or other small items. Do not add fabric softener sheets once the load has become warm. They may cause fabric softener stains. Bounce® Fabric C ...

The Exterior: Wipe or dust any spills or washing compounds with a damp cloth. Dryer control panel and finishes may be damaged by some laundry pretreatment soil and stain remover products. Apply these products away from the dryer. The fabric may then be washed and dried normally. Damage to your dryer caused by these products is not covered by your warranty. The Lint Filter: Clean the lint filter before each use. Moisten your fingers and reach into the filter opening. Run your fingers across the filter. Have a qualified technician vacuum the ...

more energy and run longer if it is not vented to the below specifications. Carefully follow the details on Exhausting in the Installation Instructions. I Use only rigid metal 4″ diameter ductwork inside the dryer cabinet. Use only rigid metal or flexible metal 4″ diameter ductwork for exhausting to the outside. I Do not use plastic or other combustible ductwork. I Use the shortest length possible. I Do not crush, kink or collapse the duct. I ...

or visit ge.com. You may not need to call for service. OPERATION Possible Causes What To Do Control pads not Controls accidentally put in • Press STOP. responding service mode Dryer doesn’t start Control panel is “asleep” • This is normal. Press POWER to activate the control panel. Dryer is unplugged • Make sure the dryer plug is pushed completely into the outlet. Fuse is blown/circuit breaker • Check the building’s fuse/circuit breaker box and is tripped replace fuse or ...