Knoll MA250 Installation Instructions

Text of Knoll MA250 Installation Instructions

Trigger does not 1. Measure trigger voltage with a voltmeter. It

work needs to be 11-16 volts DC to work (current is about 35mA total per amp). See page 5 for details. Speaker pops 1. Speaker may need resistor placed across terminal. when MA250 is Suggest 2000 ohm 1/4 watt. This discharges the turned on or off speaker internal capacitor if it has one. Warranty Knoll Systems warrants MA250 amplifiers sold in the USA and

Precautions: The amplifier is a wideband design with

substantial power output capability. Certain precautions must be taken to ensure proper operation: 1. Never expose the unit to moisture. 2. Never plug an input cable into the amplifier while the amplifier is turned on. 3. Never apply the “thumb test” (touching the “hot” lead of the input cable with your finger) to the tip of the input cable or input jack of the amplifier. RF rectification and/or

Hum and noise

In most cases, one of the following suggestions should help you solve a hum noise in your system. Please try these steps in the order shown, proceeding from one step to the next if the prior suggestion does not eliminate the problem. Suggestion #1 To determine if a cable TV connection is responsible for the hum, first turn off all the components. Disconnect the cable TV feed to your system at the first place where it connects to your componen

9. If a video signal is being used to trigger the MA250 on and

off, connect good quality short as possible video wire with a RCA jack to the MA250 “Video Input”. Make sure the music sense button is OUT. 10. If the music sense or video input is being used to turn the MA205 on and off, set the “Music Sense” button to OUT. Adjust the Sens (sensitivity) so the MA250 turns on when quieter sound passages are playing. Adjust the “Delay” so the MA250 t

Knoll Amplifier Owners Instructions: