Phonak iView Operation & User’s Manual

8 Operating time 10 Turning iView ON/OFF 10 Operating range 11 Using iView 12 Information on the screen 12 Reading out the hearing instrument status 13 Possible error messages 18 ...

21 Safety notice 22 Important points 23 Troubleshooting 26 Service and warranty 28 Declaration of conformity 29 Phonak distributors worldwide 30 ...

system status viewer from Phonak. iView provides clear information about the status of the hearing system at the touch of a button. Battery life, volume level, current program and serial number can be easily monitored on the color LCD display. Please read this manual carefully to benefit from all the features of your new iView. Ask your hearing care professional if you have any questions. For further informa ...

� Color LCD display � Status read out button � Mini USB connection � Reset button � ...

iView has an internal, rechargeable battery. To charge it, connect the charging cable to iView as shown in the picture below. Plug the other end of the charging cable into a power outlet. Do not use iView while charging. For safety reasons, recharge the battery only with chargers supplied by Phonak. 8 Getting started ...

the screen will flash. Once the battery is fully charged, the battery symbol will stop flashing. Charging an empty battery typically takes about 90 minutes. It is safe to leave the charger connected overnight – the battery cannot be overcharged. When charging iView for the first time, leave it to charge for five hours, even if the battery symbol stops flashing. A new battery’s full performance is ach ...

battery symbol on the screen (see page 12). Battery consumption and the operating time greatly depend on the usage of the device. If used regulary, iView will run for several weeks before needing recharging. Turning iView ON/OFF To turn iView ON/OFF, press and hold the ON/OFF button for about a second until you see the display turn ON/OFF. ...

used for more than one minute. Operating range The status read out range is up to 50 cm (20''). ...

� Status of right hearing instrument � Status of left hearing instrument � iView battery status � Hearing instrument program � Hearing instrument volume change in dB relative to start-up level � Hearing instrument battery status � Hearing instrument serial number � � Using iView � � � � � ...

Press the status read out button to initiate the read out process. After the status is read out successfully, the settings for the left and right hearing instruments will be displayed. If you are trying to read out the status of two hearing instruments, but only one is displayed, reduce the distance and try again. If it still doesn't work, check if the hearing instrument is turned on or replace the hearing aid b ...

Hearing program A � Automatic P1–P5 � Program 1–5 FM � Program for FM signal only FM+M � Program for FM signal and hearing instrument microphone T � Program for T-coil M+T � Program for hearing instrument microphone and T-coil � Mute ? � unknown program Ask your hearing care professional for detailed information regarding individual hearing programs. Using iView ...

� The battery is ok � The battery is approaching exhaustion and has to be replaced Using iView ...

In the event that the readout process fails, the following screen will be displayed: Reduce the distance to the hearing instruments and try again. If it still doesn’t work, check if the hearing instruments are turned on or replace the hearing aid batteries and press the read out button again. Using iView ...

are in range, the following screen will be displayed: Separate the hearing instruments that you want to read out from the others and press the read out button again. 19 ...

press the reset button on the back of the device as shown in the picture. Reset button ...