Planet ADE-4110 Operation & User’s Manual

The products and programs described in this User’s Manual are licensed products of PLANET Technology, This User’s Manual contains proprietary information protected by copyright, and this User’s Manual and all accompanying hardware, software, and docu- mentation are copyrighted. N ...

TV is showing interference, if the interference disappears when you turn your Ethernet Switch off and reappears when you turn it back on, there is interference being caused by the Ethernet Switch. You can try to correct the interference by one or more of the following ...

1. INTRODUCTION .................................................................................................................. 1 1.1 Features .............................................................................................................................................. 1 1.2 System Requirements............................ ...

6.2 ATM Status ........................................................................................................................................ 39 6.3 ADSL Configuration............................. ...

complished via a simple intuitive Web interface which further enhances the user experi- ence. 1.1 Features l ADSL Compliance n Compliant with ADSL standards u Full-rate ANSI T1.413 Issue 2 and ITU G.dmt (G.992.1) standards u Splitterless ITU G.lit ...

l Pentium III 266 MHz processor minimum l 128 MB RAM minimum l 20 MB of free disk space minimum l Ethernet Network Interface Controller (NIC) RJ45 Port l Internet Browser l Ethernet (CAT5) Cable ...

When selecting the location for the Router, allow room to access the connections on the rear panel. You will want to place the Router so that you will be able to see the LED indi- cators on the front panel. It may be convenient for you locate the Router near the PC you intend to use for initial configuration of the Router. 2.1 Front ...

The LED Indicators read as follows: PWR Illuminated when the unit is powered on. ADSL Illuminated when the physical layer link is activated. TX Illuminated when transmitting data to the ADSL line. RX Illuminated when receiving data from the ADSL line. LNK/ACT Illuminated when the device is connected to LAN port(s). 100 Illuminated when t ...