Hilti TE2 Operating Instructions Manual

cates points of particular importance to safety. The instructions at these points must always be observed in order to avoid the risk of serious injury. Caution: high voltage
The numbers refer to the illustrations. The illustra- tions can be found on the fold-out cover pages. Keep ...

Use Required insert tools Diameter range TE2 / TE2-E / TE2-S / TE2-M: Hammer drilling in concrete, Drill bits with TE-C connection end Drilling in concrete: masonry and natural stone – Short hammer drill bits Anchor holes of 4–22 mm dia. – Long hammer drill bits Through holes of 4–22 mm dia. TE2-S: ...

100 V 110 V 120 V 220 V 230 V 240 V Nominal current input ✱ 6.9 A 6.5 A 6.1 A 3.1 A 3.0 A 2.9 A Mains frequency 50–60 Hz Weight of tool without side handle 2.4 kg (TE2 / TE2-S / TE2-E) 2.7 kg (TE2-M) Weight as per EPTA-Procedure 01/2003 2.7 kg (TE2 / TE2-S / TE2-E) 2.9 kg (TE2-M) Dimensions (l×h ...

-WARNING- Read all instructions! Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term "power tool" in all of the warnings listed below refers to your mains operat- ed (corded) power tool or battery operated (cordless) power tool. SAVE THESE INSTRUCTIONS 1 ...

2.1 Personal safety a) Wear ear protectors. Exposure to noise can cause hearing loss. b) Use auxiliary handles supplied with the tool. Loss of control can cause personal injury. c) Always hold the tool with both hands on the grips provided. Keep the grips dry, clean and free from oil and grease. d) Exercise your fingers durin ...

mum operating temperature before the hammering mech- anism begins to operate. Switch on the tool and position the tip of the drill bit on the work surface. While the tool is running, apply light pressure briefly and repeatedly until the hammering mechanism begins to operate. Operation CAUTION: In ...

Care of the tool The outer casing of the tool is made from impact-resis- tant plastic. Grip sections, the dust shield and the sup- ply cord protective sleeve are made from an elastomer material. Clean the outside of the tool at regular inter- vals using a slightly damp cloth. Don’t use a spray, steam pressure cleaning equipment o ...

Hilti warrants that the tool supplied is free of defects in material and workmanship. This warranty is valid so long as the tool is operated and handled correctly, cleaned and serviced properly and in accordance with the Hilti Operating Instructions, and the technical sys- tem is maintained. This means that only origin ...

Fault in the electric power supply Plug in another electric tool and check whether it starts Defective supply cord or plug Have it checked by an electrical specialist and replace if necessary Switch defective Have it checked by an electrical specialist and replace if nece ...